User manual
BUZZER permanent off 1. Turn the programme selector to any programme.
2.
Press simultaneously the
INTENSIVE and ANTI-CREASE
buttons and hold down for approx. 5 seconds.
3. The buzzer is by default always off.
Water hardness
Water contains, a variable
quantity of limestone and miner-
al salts of which quantities vary
according to geographical loca-
tions thus varying its conductivi-
ty values.
Relevant variations of the con-
ductivity of the water compared
to those prefixed by the factory
could slightly influence the re-
sidual humidity of the laundry at
the end of the cycle. Your dryer
allows you to regulate the sen-
sitivity of the drying sensor
based on conductivity values of
the water.
1. Turn the programme selector to any programme.
2.
Press simultaneously the
ANTI-CREASE and START/
PAUSE buttons and hold down for approx. 5 seconds. The current
setting is on the display:
–
low conductivity <300 micro S/cm
–
medium conductivity 300-600 micro S/cm
–
high conductivity >600 micro S/cm
3. Press the START/PAUSE button sequentially until you set desired
level.
4.
To memorize setting press simultaneously the the
ANT-ICREASE
and START/PAUSE buttons or turn knob to O off position
Hints for test institutes
Parameters possible to checked by the Test In-
stitutes:
• Energy consumption (corrected with final hu-
midity) during the cupboard dry cotton cycle
with nominal load.
• Energy consumption (corrected with final hu-
midity) during the cupboard dry cotton cycle
with half load.
• Final humidity (during cupboard dry cotton,
iron dry cotton and cupboard dry easy care)
• Condensation efficiency (corrected with final
humidity) during cupboard dry cotton cycle
with nominal and half load
All the cycles have to be checked in accord-
ance with EN 61121 (Tumble dryers for house-
hold use – Methods for measuring the perform-
ance).
15
www.zanussi.com