User manual Washerdryer ZWD 12270 W1 ZWD 12270 S1 ZWD 12270 G1 ZWD 14270 W1 ZWD 16270 W1
Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document. The user manual should be passed on to any future owner of the appliance.
Safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features.
Use ● ● ● ● ● ● ● ● ● ● 4 This appliance is designed for domestic use. It must not be used for purposes other than those for which it was designed. Only wash and dry fabrics which are designed to be machine washed and dried. Follow the instructions on each garment label. Do not overload the appliance. See the relevant section in the user manual. Before washing, ensure that all pockets are empty and buttons and zips are fastened.
Description of the appliance 1 Detergent dispenser drawer 2 Control panel 3 Door opening handle 4 Drain pump 5 Adjustable feet 1 2 3 4 5 Detergent dispenser drawer Prewash Wash Fabric Softener 5
Control panel and functions 1 2 3 4 5 6 7 8 Control Panel key symbols: = «No spin» option, = «Rinse Hold» option, = Child safety lock Information The control panel is illustrated above. It shows the programme selector dial as well as the different buttons, the pilot lights and the display. These are represented by relevant numbers which are explained in the table below.
4 Extra Rinse button ● ● 5 Display By pressing this button, the machine performs some additional rinses. The display shows the following information: duration of the selected programme, selected drying time, incorrect option selection, alarm codes, heating phase, child safety lock and end of programme. This button allows you to start the selected programme; the corresponding green pilot light stops flashing.
Display 2.05 5.3 5.2 The display ( 5 ) shows the following information: 5.1 Duration of the selected programme/ After selecting a programme the duration of the selected programme appears on the display (e.g. 2.05). During the programme, the time remaining is updated every minute. After having pressed button 6 , the light 8.1 illuminates and stays on. /Selected drying time After selecting a drying programme, the drying time is displayed in minutes or in hours and minutes (max 250 mins = 4.
Functions No spin (button 2 ) By selecting this option all the spinning phases are suppressed to prevent the fabrics from creasing. The final spin is replaced by a draining phase. Rinse Hold (button 2 ) By selecting this option the water of the last rinse is not emptied out to prevent the fabrics from creasing. When the programme has finished, the Start/Pause and the «Wash» light go off, the «End»( 8.3 ) pilot light illuminates, the display shows three flashing zeros «0.
Programme table Programme/ Temperature Type of laundry Options Spin red. Prewash, Intensive, Super Quick(*), Extra rinse Description of programme Main wash, rinses Long spin at max speed Max Load: 6 Kg Reduced Load: 3 Kg Cottons 90° White cotton (normally soiled cotton items Cottons 60° Eco White and fast coloured cotton (normally soiled cotton items) Cottons 60° - 40° Coloured cotton normally soiled Spin red.
Programme table Programme/ Temperature Type of laundry Wool 40° Programme for wool «Pure new wool, nonshrink, machine washable» label. Handwash 30° - Cold Special programme for hand washing fabrics Mini 30’ 30° Short cycle for lightly soiled fabrics Silk 30° Silk items to be gently washed and spun. Rinse Separate rinse cycle for hand washed cotton items. Drain For emptying out the last rinse water in programmes with the «Rinse Hold» option. Spin Separate spin for cottons. Options Spin red.
Drying Times Degree of drying Suitable for items to put away without ironing Type of fabric Cotton and linen* (bathrobes, bath towels, etc Load Spin speed Suggested drying time (mins) 4 kg 1600 rpm 1400 rpm 1200 rpm 130 - 150 140 - 160 150 - 170 1600 rpm 75 - 85 1400 rpm 80 - 90 1200 rpm 85 - 95 1600 rpm 35 - 45 1400 rpm 40 - 50 1200 rpm 45 - 55 2 kg 900 rpm 70 - 80 1 kg 900 rpm 35 - 45 1600 rpm 1400 rpm 1200 rpm 1600 rpm 1400 rpm 1200 rpm 1600 rpm 1400 rpm 1200 rpm 100 - 120 11
Programme information Eco programmes Wool and Handwash This programme can be selected for slightly or normally soiled cotton items. The temperature will decrease and the washing time will be extended. This allows you to obtain a good washing efficiency whilst saving energy. Washing programme for machine washable wool as well as for hand washable woollens and delicate fabrics with the «hand washing» care symbol . Silk Delicate washing programme suitable for silk and mixed synthetics items.
Washing and drying hints Sorting the laundry Follow the wash code symbols on each garment label and the manufacturer’s washing instructions. Sort the laundry as follows: whites, coloureds, synthetics, delicates, woollens. Temperatures 90° or 95° for normally soiled white cottons and linen (e.g. tea cloths, towels, tablecloths, sheets...) 50°/60° for normally soiled, colour fast garments (e.g. shirts, night dresses, pyjamas....) in linen, cotton or synthetic fibres and for lightly soiled white cotton (e.
Maximum loads Recommended loads are indicated in the programme charts. General rules: Cotton, linen: drum full but not too tightly packed; Synthetics: drum no more than half full; Delicate fabrics and woollens: drum no more than one third full. Washing a maximum load makes the most efficient use of water and energy. For heavily soiled laundry, reduce the load size.
The choice of detergent will depend on the type of fabric (delicates, woollens, cottons, etc.), the colour, washing temperature and degree of soiling. All commonly available washer-dryer detergents may be used in this appliance: ● powder detergents for all types of fabric, ● powder detergents for delicate fabrics (60°C max) and woollens, ● liquid detergents, preferably for low temperature wash programmes (60°C max) for all types of fabric, or special for woollens only.
Before the first use WARNING! Ensure that the electrical and water connections comply with the installation instructions. IMPORTANT! Remove the polystyrene block and any material from the drum. IMPORTANT! Pour 2 litres of water into the main wash compartment of the detergent drawer in order to activate the ECO valve. Then run a cotton cycle at 90°C or 95°C, without any laundry in the machine, to remove any manufacturing residue from the drum and tub.
Operating sequence - Washing only Washing 1. Load the laundry Open the door by carefully pulling the door handle outwards. Place the laundry in the drum, one item at a time, shaking them out as much as possible. Close the door. Measure out the detergent and the fabric softener Pull out the dispenser drawer until it stops. Measure out the amount of detergent required, pour it into the main wash compartment and, if you wish to carry out the prewash phase, pour it into the compartment marked .
Start the programme by pressing button 6 To start the selected programme, press this button; the corresponding green pilot light stops flashing. The appliance starts operating and the door is locked. To interrupt a programme which is running, depress the button 6 : the corresponding green pilot light starts to flash. To restart the programme from the point at which it was interrupted, press the same button again.
Turn the programme selector dial to «Off» to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells. Stand by: once the programme has finished after a few minutes the energy saving system will be enabled. The brightness of the display is reduced.
NON-STOP programme (Washing and Timed Drying) The recommended load to wash and dry in your washer-dryer is 3 kg for cotton and 2 kg for synthetics. Note! It is possible also to wash and dry up to 4 kg of cotton items (see the drying times table). Do not use a dosing device/ball when carrying out a washing & drying programme. 1. Load the laundry. 2. Add detergent and fabric softener. 3. Switch the machine on by turning the selector dial to the selected wash programme/fabric. 4.
Care and cleaning IMPORTANT! You must DISCONNECT the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. Descaling The water we use normally contains lime. It is a good idea to periodically use a water softening powder in the machine. Do this separately from any laundry washing, and according to the softening powder manufacturer's instructions. This will help to prevent the formation of lime deposits.
Care and cleaning • Replace the emergency emptying cap into the filter cover and fix it firmly. 1 2 • pull out the emergency emptying cap from the filter cover, using a pliers. • When no more water comes out,unscrew the pump cover by turning it anti-clockwise, using pliers, and remove the filter. Always keep a rag nearby to dry up any water spillages when removing the cover. Clean the filter under a tap, to remove any traces of fluff. • Close the pump door.
Care and cleaning Turn off the water tap. Unscrew the water inlet hose. Clean the filter using a hard bristle brush. Tighten up the inlet hose. The dangers of freezing If the machine is exposed to temperatures below 0°C, certain precautions should be taken: • pull out the plug from the power socket; • turn off the water tap. • unscrew the inlet hose. • place a bowl with a small edge close to the pump to collect any spillage from the emergency emptying hose.
What to do if... IMPORTANT! Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below. During machine operation it is possible that the red pilot light of the button 6 flashes, the buzzer sounds and one of the following alarm codes appears on the display to indicate that the machine is not working.
Malfunction The machine fills then empties immediately: The machine does not empty and/or does not spin: Possible Cause / Solution The end of the drain hose is too low. • Refer to relevant paragraph in «water drainage» section. The drain hose is squashed or kinked. E20 • Check the drain hose connection. The drain pump is clogged. E20 • Clean the drain pump. The Rinse Hild or No spin option has been selected. • Select the Drain or Spin programmes The laundry is not evenly distributed in the drum.
Malfunction The door will not open: Possible Cause / Solution The programme is still running. • Wait until the end of washing cycle. The door lock has not been released. • Wait a few minutes. There is water in the drum. • Select drain or spin programme to empty out the water. The transit bolts and packing have not been removed. • Check the correct installation of the appliance. The machine vibrates or is noisy: The support feet have not been adjusted. • Check the correct levelling of the appliance.
Malfunction Possible Cause / Solution The machine does not dry or does not The drying time has not been selected. dry properly • Select the drying time. The water tap is not turned on (E10) • Open the water tap. The drain filter is clogged (E20) • Clean the drain filter. The machine is overloaded. • Reduce the laundry load. The selected drying time was not suitable for the laundry. • Select the suitable drying time for the laundry. 28 ... ... No. .. Ser. ... ... ... ...
Technical data Dimensions Width 60 cm Height 85 cm Depth (including the porthole) 63 cm Electrical connection Voltage Overall power - Fuse Information on the electrical connection is given on the rating plate on the inner edge of the appliance door Water supply pressure Minimum 0,05 MPa Maximum 0,8 MPa Maximum Load Cotton Synthetics Delicates Woollens and handwash 6.0 3.0 3.0 2.0 Maximum Drying Load Cotton Cotton Big Capacity Synthetics Spin Speed Maximum kg kg kg kg 3.
Consumption values Cottons 90°C Cottons 60° Eco(*) Cottons 60°C - 40°C Cottons 40° Eco Synthetics 50°C - 40°C Synthetics Easy Iron 40°C Delicates 40°C - 30°C Wool 40°C Programme duration (in minutes) For the duration of the programmes, please refer to the display on the control panel Programme Energy consumption (in kWh) Water consumption (in litres) 2.0 61 1.02 54 1.3 58 1.14 54 0.8 51 0.35 60 0.55 60 0.
Installation instruction Unpacking All transit bolts and packing must be removed before using the appliance. You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again. 5. Open the porthole and remove the polystyrene block fitted on the door seal. 6. Fill the smaller upper hole and the two large ones with the corresponding plastic plug caps supplied in the bag containing the instruction booklet. 1.
Special conditions If the floor is carpeted or covered with crumbly or soft material, insert a rigid support base under the feet to prevent noise, vibration or displacement. The base should protrude a few centimetres beyond the edges of the machine. WARNING! The machine should NOT be placed on deep pile carpeting. NOTE Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown.
When discharging into a standpipe ensure that the top of the standpipe is no more than 90 cm (35.4'') and no less than 60 cm (23.6'') above floor level. Special Sport 40° Sport Shoes 40° Off Cottons 95° 60° Eco Silk 60° Mini 30' 40° Eco 3h 6h 9h 1000 900 700 Wash Prewash Door Intensive 40° Synthetics 50° Cold Hand Wash 30° End Super Quick Spin Options Extra Rinse Start/Pause 40° Wool Easy Iron 40° Spin 40° Drain 30° ZWF10070W Delicates Min. 60 cm (23.6) Rinse Max.
Electrical connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath. WARNING! This appliance must be earthed. The manufacturer declines any liability should this safety measure not be observed.
600 820 820 600 595 600 The top must be fixed to the cabinet as follows: Unscrew the screws from the back panel of the appliance. Push the worktop to the back and raise it to remove (see the picture above). Environmental concerns Packaging materials The materials marked with the symbol recyclable. >PE<=polyethylene are >PS<=polystyrene >PP<=polypropylene This means that they can be recycled by disposing of them properly in appropriate collection containers.
www.electrolux.com www.zanussi-electrolux.co.