User manual

19
IMPORTANT!
The door will be locked throughout the delay
time. If you need to open the door, you must
first set the washing machine to PAUSE by
pressing the Start/Pause button, wait until the
«Lock» pilot light goes off. After you have
closed the door, press the Start/Pause button
again.
Note! The Delay Start cannot be selected
with Drain programme.
Altering an option or a running programme
It is possible to change any option before the
programme carries it out. Before you make any
change, you must pause the washing machine
by pressing the Start/Pause button.Changing a
running programme is possible only by
resetting it. Turn the programme selector dial to
Off and then to the new programme position.
Start the new programme by depressing the
Start/Pause button again.The washing water in
the tub will not empty out.
Interrupting a programme
Depress the Start/Pause button to interrupt a
programme which is running, the
corresponding light starts to flash. Depress the
button again to restart the programme.
Cancelling a programme
Turn the selector dial to Off to cancel a
programme which is running. Now you can
select a new programme.
Opening the door after the programme has
started
First set the machine to pause by pressing the
Start/Pause button.If the «Lock» light goes off
after a few minutes, the door can be opened.If
the «Lock» light does not switch off, this means
that the machine is already heating, that the
water level is too high.In this case the door can
not be opened.If you cannot open the door but
you need to open it you have to switch the
machine off by turning the selector dial to
«Off». After about a few minutes the door can
be opened (pay attention to the water level and
temperature!).
At the end of the programme
The machine stops automatically. The
Start/Pause light goes off, the «Lock» light
goes off and on the display will appear a
flashing «
0.00». The door can be opened.If
the «Rinse hold» or «Night Cycle»
option has been selected, the «Lock» light
remains alight and the door is locked to
indicate that the water must be emptied out
before opening the door. The display will show
a flashing «0.00».To empty out the water
please read the steps on the Rinse Hold option
paragraph.Turn the programme selector dial to
«Off» to switch the machine off. Remove the
laundry from the drum and carefully check that
the drum is empty.If you do not intend to carry
out another wash, close the water tap. Leave
the door open to prevent the formation of
mildew and unpleasant smells.
Operating sequence
Smart 132973880.qxd 02/07/2008 11.41 Pagina 19