User manual

Always obey the instructions that you
find on the packaging of the detergent
products.
Detergent compartment for prewash or soak
phase.
The prewash and soak detergent must be
added at the beginning of the wash pro-
gramme.
Compartment for powder or liquid detergent
used for main wash. If using liquid detergent,
pour it just before starting the programme.
Compartment for liquid additives (fabric con-
ditioner, starch).
Follow the product manufacturer’s recom-
mendations on quantities to use and do not
exceed the maximum mark in the detergent
dispenser drawer.
USING DETERGENT AND ADDITIVES
Open the detergent
drawer .
Measure out the deter-
gent.
Measure out the fabric
conditioner.
Carefully close the deter-
gent drawer.
SETTING A PROGRAMME
1. Turn the programme knob to switch the
appliance on and set the programme:
• The indicator of the button flashes.
• The display shows the programme duration.
2. If necessary, change the temperature and the
spin speed or add available options. When you
activate an option, the indicator of the set
option comes on.
If you set something incorrect, the
display shows the message .
Autosense function
At the start of the programme, the display shows
the programme duration for the maximum load
capacity. During the washing phase the programme
duration is automatically calculated and can be
greatly reduced if the laundry load is lower than the
maximum load capacity. When the appliance is
calculating the real programme duration the display
is alternatively showing the " loading " animation
and the max load capacity time duration .The
new time duration is appearing when calculation is
finished. (e.g. Cotton 30° programme , maximum
load capacity 8 kg , the default programme duration
exceeds 2 hours, in case of actual load 2 kg, the
program duration will be reduced to only 1 hour 20
min).
STARTING A PROGRAMME WITHOUT THE
DELAY START
Press the button .
• The indicator of the button
stops to
flash and stays on.
• The programme starts, the door locks, the
indicator is on.
• The programme time decreases with steps
of one minute.
The drain pump can operate for a
short time at the beginning of the
washing cycle.
STARTING A PROGRAMME WITH THE DELAY
START OPTION
1. Press the button Delay Start again and
again until the display shows the delay you
want to set. The delay start indicator comes on.
2. Press the button Start/Pause :
• The door is locked and the indicator
is
on.
12