User manual

• The appliance starts the countdown.
• When the countdown is completed, the
programme starts automatically.
You can cancel or change the set of
the Delay Start option before you
press the button Start/Pause .
After pressing the button Start/Pause
you can only cancel the Start/
Pause option.
To cancel the Delay Start option:
a. Press the button Start/Pause to set
the appliance to pause. The indicator of
button flashes.
b. Press the button Delay Start until the
display shows .
Press the Start/Pause button again to
start the programme immediately.
INTERRUPTING A PROGRAMME AND
CHANGING THE OPTIONS
You can change only some options before the
programme carries them out.
1. Press the Start/Pause button to interrupt
the running programme.
The related indicator flashes.
2. Change the options.
3. Press the Start/Pause button again.
The programme continues.
CANCELLING A RUNNING PROGRAMME
1. Turn the programme knob to position to
cancel the programme and to deactivate the
appliance.
2. Turn the programme knob again to activate the
appliance. Now, you can set a new washing
programme.
Before starting the new programme
the appliance could drain the water. in
this case, make sure that the detergent
is still in the detergent compartment, if
not fill the detergent again.
OPENING THE DOOR WHEN THE DELAY
START OPERATES
While the delay start operates, the appliance door
is locked and the display shows the indicator .
1. Press Start/Pause to pause the appliance.
2. Wait until the door lock indicator
goes off.
3. Open the door.
4. Close the door.
5. Press Start/Pause again.
The delay start continues to operate.
OPENING THE DOOR WHEN THE
PROGRAMME OPERATES
While the programme operates, the appliance door
is locked and the indicator appears.
CAUTION! If the temperature and
level of the water in the drum are too
high, you cannot open the door.
1. Turn the programme knob to position to
deactivate the appliance.
2. Wait some minutes until the indicator goes
off and then open carefully the appliance door.
3. Close the appliance door.
4. Set the programme again.
AT THE END OF THE PROGRAMME
• The appliance stops automatically.
• The acoustic signal operates (if it is activated).
• In the display three flashing zeros come on.
• The indicator of the Start/Pause goes off.
• The door lock indicator goes off.
• You can open the door.
• Remove the laundry from the appliance. Make
sure that the drum is empty.
• Close the water tap.
• Turn the programme knob to the position to
deactivate the appliance.
• Keep the door ajar, to prevent the mildew and
odours.
The washing programme is completed, but
there is water in the drum:
• The drum turns regularly to prevent the creases
in the laundry.
• The door lock indicator is on. The door
stays locked.
• You must drain the water to open the door.
To drain the water:
1. Turn the programme knob to spinning or
draining programme.
2. Press the button Start/Pause . If necessary,
decrease the spin speed.
The appliance spins and drains or only drains.
13