User manual

Important! The Time Manager cannot be
selected with the Economy (Eco)
programmes.
The availability of these soil level icons change
according to the type of fabric as shown in the
following chart.
Fabric Soil Level
Cottons
95°/90°C X X X X X X
60°C/50°C X X X X X X
40°C X X X X X X
30°C X X X X X X
Cold X X X X X X
Synthetics
60°C/50°C X X X X
40°C X X X X
30°C X X X X
Cold X X X X
Delicates
40°C X X X X
30°C X X X X
Cold X X X X
Altering an option or a running
programme
It is possible to change some options before
the programme carries them out .
Before you make any change, you must PAUSE
the appliance by pressing the button 8 (if you
wish to change the Time Manager option, you
must cancel the running programme and make
your selection again).
Changing a running programme is possible only
by resetting it. Turn the programme selector di-
al to
and then to the new programme posi-
tion. Start the new programme by pressing the
button 8 again. The washing water in the tub
will be not emptied out.
Interrupting a programme
Press the button 8 to interrupt a programme
which is running, the corresponding green pilot
light starts blinking.
Press the button again to restart the pro-
gramme.
Cancelling a programme
Turn the selector dial to
to cancel a pro-
gramme which is running.
You can select now a new programme.
Opening the door
After the programme has started (or during the
delay time) the door is locked, if you need to
open it, set first the machine to PAUSE by
pressing the button 8.
If the icon 7.10 after a few minutes disappears
from the display, the door can be opened.
If the icon 7.10 does not go off, this means that
the machine is already heating or that the water
level is too high. Do not try to force the door!
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to
. After a few mi-
nutes the door can be opened (pay attention
to the water level and temperature!).
After closing the door, it is necessary to select
the programme and options again and to press
button 8.
At the end of the programme
The machine stops automatically. Three blinking
0.00 appear on the display and the pilot light of
button 8 goes off. Some acoustic signals
sound.
If a programme or an option that ends with wa-
ter left in the tub has been set, the door re-
mains locked to indicate that the water must be
emptied out before opening the door.
Before you empty out the water, the drum con-
tinues to run at regular intervals until the water
draining.
Follow the below instructions to empty out the
water:
1.
Turn the programme selector dial to
.
2. Select the draining or spinning programme.
3. Reduce the spin speed if needed, by
pressing the relevant button.
4. Press button 8.
At the end of the programme, the door is re-
leased and can be opened. Turn the pro-
17
www.zanussi.com