User manual

Place a container
close to the pump .
Unscrew carefully the
drain filter to drain out
the water.
When no more water comes out, remove the
filter. If necessary, use pliers.
Always keep a rag nearby to dry up any water
spillage when removing the filter.
Clean the filter under a tap, to remove any
traces of fluff.
Remove foreign bod-
ies and fluff from the
pump impeller.
Check carefully whether the pump impeller
rotates (it rotates jerkily). If it doesn’t rotate,
please contact the Service.
Replace the filter into
the pump by inserting
it correctly into the
special guides.
Screw firmly the filter.
Close the pump door.
Caution! When the appliance is in use
and depending on the programme
selected there can be hot water in the pump.
Never remove the filter during a wash cycle.
Always wait until the appliance has finished the
cycle, and is empty.
When refitting the filter, ensure it is securely re-
tightened so as to stop leaks and young
children being able to remove it.
Cleaning the water inlet filters
If the appliance doesn't fill, takes long to fill
with water, the starting button blinks red or
the display (if available) shows the relevant
alarm (see chapter "What to do if..." for more
details), check if the water inlet filters are
blocked .
To clean the water inlet filters:
1
2
3
• Turn off the water
tap.
• Unscrew the hose
from the tap.
• Clean the filter in
the hose with a stiff
brush.
• Screw the hose back onto the tap. Make
sure the connection is tight.
• Unscrew the hose
from the machine.
Keep a rag nearby
because some wa-
ter may flow.
• Clean the filter in
the valve with a
stiff brush or with
the piece of cloth.
35°
45°
• Screw the hose back to the machine and
make sure the connection is tight.
• Turn on the water tap.
19
www.zanussi.com