User manual

Frost precautions
If the machine is installed in a place where the
temperature could drop below 0°C, remove the
remaining water from the inlet hose and the
drain pump.
1. disconnect the mains plug from the mains
socket.
2. close the water tap
3. unscrew the water inlet hose from the tap;
4. put the two ends of the inlet hose in a con-
tainer and let the water flow out of the
hose.
5. empty the drain pump as described in the
‘Emergency emptying out’ section.
6. when the drain pump is empty, install the
water inlet hose again.
Warning!
Make sure that the temperature is more than 0
°C before you use the appliance again.
The manufacturer is not responsible for dam-
ages caused by low temperatures.
Emergency emptying out
If the water is not discharged, proceed as fol-
lows to empty out the machine:
1. Pull out the plug from the power socket.
2. Close the water tap.
3. If necessary, wait until the water has
cooled down.
4. Open the pump door.
5. Place a bowl on the floor.
6. Unscrew carefully the filter. When the bowl
is full, screw the filter again.
– The water drain out by gravity into the
bowl.
– Empty the bowl.
– Repeat the procedure until water stops
flowing out.
7. Clean the pump if necessary as previously
described.
8. Screw firmly the filter again and close the
door pump.
Important! Every time you drain the water
through the emergency emptying hose you
must pour 2 litres of water into the main wash
compartment of the detergent drawer and then
run the drain programme. This will activate the
ECO Valve device avoiding that part of the
detergent remains unused at next washing.
What to do if…
Certain problems are due to lack of simple
maintenance or oversights, which can be
solved easily without calling out an engineer.
Before contacting your local Service Centre,
please carry out the checks listed below.
During machine operation it is possible that the
red pilot light of button 8 blinks, one of the fol-
lowing alarm codes appears on the display and
some acoustic signals sound every 20 seconds
to indicate that the machine is not working:
•
: problem with the water supply.
•
: problem with the water draining.
•
: door open.
Once the problem has been eliminated, press
the button 8 to restart the programme. If after
all checks, the problem persists, contact your
local Service Centre.
20
www.zanussi.com