User manual

ceed the «MAX» mark in the detergent dis-
penser drawer.
Quantity of detergent to be used
The type and quantity of detergent will depend
on the type of fabric, load size, degree of soiling
and hardness of the water used.
Follow the product manufacturers’ instructions
on quantities to use.
Use less detergent if:
• you are washing a small load
• the laundry is lightly soiled
• large amounts of foam form during washing.
Degrees of water hardness
Water hardness is classified in so-called “de-
grees” of hardness. Information on hardness of
the water in your area can be obtained from the
relevant water supply company, or from your lo-
cal authority. If the water hardness degree is
medium or high we suggest you to add a water
softener following always the manufacturer’s in-
structions. When the degree of hardness is soft,
readjust the quantity of the detergent.
First use
• Ensure that the electrical and water con-
nections comply with the installation in-
structions.
• Remove the polystyrene block and any
material from the drum.
• Pour 2 litres of water into the main wash
compartment
of the detergent drawer
in order to activate the ECO valve. Then
run a cotton cycle at the highest temper-
ature without any laundry in the machine,
to remove any manufacturing residue
from the drum and tub. Pour 1/2 a
measure of detergent into the main wash
compartment and start the machine.
Personalisation
Acoustic signals
The machine is provided with an acoustic de-
vice, which sounds in the following cases:
• at the end of the cycle
• if there is a fault.
By pressing the 4 and 5 buttons simultaneously
for about 6 seconds, the acoustic signal is de-
activated (except if there is a fault). By pressing
these 2 buttons again, the acoustic signal is re-
activated.
Child safety lock
This device permits you to leave the appliance
unattended so you do not need to worry that
children might be injured by or cause damage to
the appliance. This function remains enabled al-
so when the washing machine is not working.
There are two different ways to set this option:
1. Before pressing button 7: it will be impossi-
ble to start the machine.
2. After pressing button 7: it will be impossi-
ble to change any other programme or op-
tion.
To enable or disable this option press simulta-
neously for about 6 seconds buttons 2 and 3
until on the display, the icon
appears or dis-
appears.
13
www.zanussi.com