User manual

After selecting a programme, the duration is
displayed in hours and minutes (for example
). The duration is calculated automati-
cally on the basis of the maximum recom-
mended load for each type of fabric. After the
programme has started, the time remaining is
updated every minute.
• Delayed start
The Selected delay set by pressing the rele-
vant button appears on the display for a few
seconds, then the duration of the selected
programme is displayed again. The delay
time value decreases by one unit every hour
and then, when 1 hour remains, every minute.
• Alarm codes
In the event of operating problems, some
alarm codes can be displayed, for example
(see paragraph «What to do if...»).
• Incorrect option selection
If an option which is not compatible with the
set wash programme is selected, the mes-
sage Err is displayed at the bottom of the
display for a few seconds. The integrated red
light of button 7 starts flashing.
• End of programme
When the programme has finished the flash-
ing zero (
) is displayed. The pilot light 9
and the pilot light of button 7 go out. The
door can be opened.
First use
• Ensure that the electrical and water
connections comply with the installation
instructions.
• Remove the polystyrene block and any
material from the drum.
• Pour 2 litres of water into the main wash
compartment
of the detergent draw-
er in order to activate the ECO valve.
Then run a cotton cycle at the highest
temperature without any laundry in the
machine, to remove any manufacturing
residue from the drum and tub. Pour 1/2
a measure of detergent into the main
wash compartment and start the ma-
chine.
Personalisation
Acoustic signals
The machine is provided with an acoustic de-
vice, which sounds in the following cases:
• at the end of the cycle
• if there is a fault.
By pressing the 4 and 5 buttons simultaneously
for about 6 seconds, the acoustic signal is de-
activated (except if there is a fault). By pressing
these 2 buttons again, the acoustic signal is re-
activated.
Child safety lock
This device permits you to leave the appliance
unattended so you do not need to worry that
children might be injured by or cause damage
to the appliance. This function remains enabled
also when the washing machine is not working.
There are two different ways to set this option:
1. Before pressing button 7: it will be impos-
sible to start the machine.
2. After pressing button 7: it will be impossi-
ble to change any other programme or op-
tion.
To enable or disable this option press simulta-
neously for about 6 seconds buttons 2 and 3
until on the display, the icon
appears or dis-
appears.
7
www.zanussi.com