User manual

• Measure out the
detergent.
• Pour the powder
detergent into the
main wash com-
partment
.
• Remove the remaining powder form
the flap.
• There is remaining powder detergent
in the main wash compartment at the
end of a washing programme. Check
if the flap is in the right position.
The flap is up and you wish to use liquid
detergent:
• Turn the flap down.
• Measure out the
detergent.
For the quantity
of detergent, re-
fer always to what is
written on the prod-
uct packing and en-
sure that the deter-
gent can be poured
in the drawer.
• Pour the liquid detergent in the compart-
ment
without exceeding the limit indica-
ted in the flap.
• Close the dispenser drawer.
Warning! Do not use the flap in "DOWN"
position with:
• Gelatinous detergent or thick detergent.
• Powder detergent.
• With programmes with prewash.
• Do not use liquid detergent if the washing
programme doesn't start immediately.
In these cases, use the flap in "UP" position .
Select the required programme by means
of the programme selector dial (1)
Turn the programme selector dial to the re-
quired programme.
The green pilot light of button 7 starts to flash.
The selector dial can be turned either clockwise
or anticlockwise.
Turn the selector dial to position
to reset the
programme/to switch the machine OFF.
At the end of the programme the selector
dial must be turned to position
, to
switch the machine off.
Important! If you turn the programme selector
dial to another programme when the machine is
working, the red pilot light of button 7 will blink
3 times and the messageErr is displayed to
indicate a wrong selection. The machine will
not perform the new selected programme.
Select the spin speed by pressing button
2
When selecting a programme, the appliance
proposes automatically the maximum spin
speed provided for that programme. (See
"Washing programmes" for the maximum al-
lowed spin speed).
Press this button repeatedly to change the spin
speed, if you want your laundry to be spun at a
different speed. The relevant pilot light illumi-
nates.
Select the available options by means of
buttons 3, 4, 5 and 6
Depending on the programme, different options
can be combined. These must be selected after
choosing the desired programme and before
starting the programme. When these buttons
are pressed, the corresponding pilot lights illu-
minate. When they are pressed again, the pilot
lights go out. If an incorrect option is selected,
the integrated red pilot light of the button 7
flashes 3 times and the message Err is dis-
played.
9
www.zanussi.com