User manual

Type of
washing cy-
cle
Soil
level
icon
Type of fabric
Super Quick
1)
For items used or
worn for a short time
1) We recommend you to reduce the load sizes (see
Washing programmes table).
Important! The Time Manager cannot be
selected with the Economy (Eco)
programmes.
The availability of these soil level icons change
according to the type of fabric as shown in the
following chart.
Fabric Soil Level
Cottons
95°/90°C X X X X X X
60°C/50°C X X X X X X
40°C X X X X X X
30°C X X X X X X
Cold X X X X X X
Synthetics
60°C/50°C X X X X
40°C X X X X
30°C X X X X
Cold X X X X
Delicates
40°C X X X X
30°C X X X X
Cold X X X X
Altering an option or a running
programme
It is possible to change some options before
the programme carries them out .
Before you make any change, you must
PAUSE the appliance by pressing the button 8
(if you wish to change the Time Manager op-
tion, you must cancel the running programme
and make your selection again).
Changing a running programme is possible on-
ly by resetting it. Turn the programme selector
dial to
and then to the new programme po-
sition. Start the new programme by pressing
the button 8 again. The washing water in the
tub will be not emptied out.
Interrupting a programme
Press the button 8 to interrupt a programme
which is running, the corresponding green pilot
light starts blinking.
Press the button again to restart the pro-
gramme.
Cancelling a programme
Turn the selector dial to
to cancel a pro-
gramme which is running.
You can select now a new programme.
Opening the door
After the programme has started (or during the
delay time) the door is locked, if you need to
open it, set first the machine to PAUSE by
pressing the button 8.
If the icon 7.10 after a few minutes disappears
from the display, the door can be opened.
If the icon 7.10 does not go off, this means that
the machine is already heating or that the water
level is too high. Do not try to force the door!
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to
. After a few mi-
nutes the door can be opened (pay attention
to the water level and temperature!).
After closing the door, it is necessary to select
the programme and options again and to press
button 8.
At the end of the programme
The machine stops automatically. Three blink-
ing 0.00 appear on the display and the pilot
light of button 8 goes off. Some acoustic sig-
nals sound.
If a programme or an option that ends with wa-
ter left in the tub has been set, the door re-
mains locked to indicate that the water must be
emptied out before opening the door.
Before you empty out the water, the drum con-
tinues to run at regular intervals until the water
draining.
Follow the below instructions to empty out the
water:
1. Turn the programme selector dial to O.
17
www.zanussi.com