User manual
Table Of Contents
- SAFETY INFORMATION
- SAFETY INSTRUCTIONS
- PRODUCT DESCRIPTION
- CONTROL PANEL
- PROGRAMMES
- CONSUMPTION VALUES
- OPTIONS
- SETTINGS
- BEFORE FIRST USE
- DAILY USE
- LOADING THE LAUNDRY
- USING DETERGENT AND ADDITIVES
- DETERGENT COMPARTMENTS
- LIQUID OR POWDER DETERGENT
- SETTING A PROGRAMME
- STARTING A PROGRAMME WITHOUT THE DELAY START
- STARTING A PROGRAMME WITH THE DELAY START OPTION
- CANCELLING A RUNNING PROGRAMME
- INTERRUPTING A PROGRAMME AND CHANGING THE OPTIONS
- OPENING THE DOOR
- AT THE END OF THE PROGRAMME
- STAND BY
- HINTS AND TIPS
- CARE AND CLEANING
- TROUBLESHOOTING
- TECHNICAL DATA
CLEANING THE DRAIN FILTER
1 2 3 4
1
2
5 6 7 8
1
2
9 1
0
CLEANING THE INLET HOSE AND THE VALVE FILTER
1
2
3
1 2 3
45°
20°
4
EMERGENCY DRAIN
Because of a malfunction, the appliance cannot
drain the water.
If this occurs, do steps (1) through (10) of
'Cleaning the drain filter'. If necessary, clean the
pump.
When you drain the water with the emergency drain
procedure, you must activate again the drain
system:
1. When you drain the water with the emergency
drain procedure, you must activate again the
drain system: Put 2 litres of water in the main
wash compartment of the detergent dispenser.
2. Start the programme to drain the water
FROST PRECAUTIONS
If the appliance is installed in an area where the
temperature can be less than 0° C, remove the
remaining water from the inlet hose and the drain
pump.
1. Disconnect the mains plug from the mains
socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in a
container and let the water flow out of the
hose.
15