User manual
Table Of Contents
- SAFETY INFORMATION
- SAFETY INSTRUCTIONS
- PRODUCT DESCRIPTION
- CONTROL PANEL
- PROGRAMMES
- CONSUMPTION VALUES
- OPTIONS
- SETTINGS
- BEFORE FIRST USE
- DAILY USE
- LOADING THE LAUNDRY
- USING DETERGENT AND ADDITIVES
- DETERGENT COMPARTMENTS
- LIQUID OR POWDER DETERGENT
- SETTING A PROGRAMME
- STARTING A PROGRAMME WITHOUT THE DELAY START
- STARTING A PROGRAMME WITH THE DELAY START OPTION
- CANCELLING A RUNNING PROGRAMME
- INTERRUPTING A PROGRAMME AND CHANGING THE OPTIONS
- OPENING THE DOOR
- AT THE END OF THE PROGRAMME
- STAND BY
- HINTS AND TIPS
- CARE AND CLEANING
- TROUBLESHOOTING
- TECHNICAL DATA
Problem Possible solution
The spin phase does not
operate or the washing cy-
cle lasts longer than usual-
ly.
• Set the spin programme.
• Make sure that the drain filter is not clogged. Clean the filter, if nec-
essary. Refer to 'Care and cleaning'.
• Adjust manually the items in the tub and start the spin phase again.
This problem may be caused by balance problems.
There is water on the floor. • Make sure that the couplings of the water hoses are tight and there
is not water leakages.
• Make sure that the drain hose have no damages.
• Make sure you use the correct detergent and the correct quantity of
it.
You cannot open the appli-
ance door.
• Make sure that the washing programme is finished.
• Set the drain or the spin programme if there is water in the drum.
The appliance makes an
unusual noise.
• Make sure the levelling of the appliance is correct. Refer to 'Installa-
tion'.
• Make sure that the packaging and/or the transit bolts are removed.
Refer to 'Installation'.
• Add more laundry in the drum. The load may be too small.
The washing results are
not satisfactory.
• Increase the detergent quantity or use a different detergent.
• Use special products to remove the stubborn stains before you
wash the laundry.
• Make sure that you set the correct temperature.
• Decrease the laundry load.
You cannot set an option. • Make sure that you press only the wanted button(s).
After the check, activate the appliance. The
programme continues from the point of interruption.
If the problem occurs again, contact the Authorised
Service Centre.
If the display shows other alarm codes. Deactivate
and activate the appliance. If the problem
continues, contact the Service.
SERVICE
We recommend the use of original spare parts.
When contacting the Authorised Service Centre,
make sure that these data are available. You can
find the information on the rating plate: model, PNC
and Serial Number. (Mod., Prod. No., Ser. No.)
TECHNICAL DATA
Dimension Width/ Height/ Depth/ To-
tal depth
595 mm / 850 mm / 450 mm / 490 mm
Electrical connection Voltage
Overall power
Fuse
Frequency
230 V
2200 W
10 A
50 Hz
Level of protection against ingress of solid particles and
moisture ensured by the protective cover, except where
the low voltage equipment has no protection against
moisture
IPX4
17