Basic Guide

Dispenser box

To clean, proceed as follows :

Drainage filter

Clean the filter located at the base of the appli-

ance regularly :

Water inlet filters

To clean, proceed as follows :

Operating Problems

Numerous checks were carried out on your ap-

pliance before it left the factory. However,

should you notice a malfunction, please refer to

the sections below before contacting the after-

sales service.

Problems Causes

The washing machine

doesn’t start or doesn’t

fill :

• the appliance isn’t plugged in correctly, the electrical installation isn’t work-

ing, there is a power failure,

• the lid of your appliance and the drum shutters aren’t closed firmly,

• the programme start command hasn’t been properly selected,

• the water supply has been cut off, the water inlet tap is closed,

• the water inlet filters are dirty,

•

a red tab appears on the water inlet hose

The appliance fills but

empties straight away :

• the drainage U-piece is fixed too low (see installation section).

The washing machine

doesn’t rinse or doesn’t

empty :

• the drain hose is blocked or bent,

• the drainage filter is obstructed,

• the out of balance detector has been activated : washing is unevenly distrib-

uted in the drum,

• the “Drain” programme or “Night Silence Plus” or “Rinse hold” option have

been selected,

• the height of the drainage U-piece is unsuitable.