User Manual GETTING STARTED? EASY.
SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference. CHILDREN AND VULNERABLE PEOPLE SAFETY WARNING! Risk of suffocation, injury or permanent disability.
• • • • • • • • • • • • • Do not install the appliance behind a lockable door, a sliding door or a door with a hinge on the opposite side, that would prevent the appliance door from being fully open. Connect the mains plug to the mains socket only at the end of the installation process. Make sure that the mains plug is accessible after installation. The ventilation opening in the base must not be covered by a carpet, mat, or any floor covering.
• • • • • • • • • • Do not use the appliance if items have been soiled with industrial chemicals. Do not dry unwashed items in the wash dryer. Items such as foam rubber (latex foam), shower caps, waterproof textiles, and rubber backed articles and clothes, or pillows fitted with foam rubber pads should not be dried in the washer dryer. Fabric softeners, or similar products, should only be used as specified by the product manufacturer’s instructions.
• When the appliance is in its permanent position, check if it is levelled correctly with the aid of a spirit level. If it is not, adjust the feet accordingly. ELECTRICAL CONNECTION WARNING! Risk of fire and electric shock. • • • • • • • The appliance must be earthed. Always use a correctly installed shockproof socket. Do not use multi-plug adapters and extension cables. Do not pull the mains cable to disconnect the appliance. Always pull the mains plug.
PRODUCT DESCRIPTION APPLIANCE OVERVIEW 1 2 3 4 5 6 1 Detergent dispenser 2 Control panel 3 Door handle 4 Rating plate 5 Drain pump filter 6 Feet for levelling the appliance CHILD SAFETY This device prevents children or pets to be closed in the drum. • Turn the device clockwise, until the groove is horizontal. You cannot close the door. • To close the door, turn the device anticlockwise until the groove is vertical.
CONTROL PANEL CONTROL PANEL DESCRIPTION 1 24 1 23 2 3 22 4 21 5 20 6 19 18 7 8 17 9 16 15 10 14 13 12 11 2 3 4 Delay Start 1200 900 700 Eco 400 Rinse Hold Door Quick Wash Spin Option Extra Rinse 10 9 8 Drying Time Easy Iron Start/Pause 7 6 5 1 Programme knob and On/Off position 2 Display 7 Drying Time button (Drying Time) 3 Delay Start button (Delay Start) 9 Options button (Option) 4 Door Locked indicator (Door) 10 Spin Reduction button (Spin) 8 Extra Rinse button (Extra Rinse)
• • After the programme start, the set delay appears for few seconds, then the duration of the set programme is displayed again. Alarm codes If the appliance has a malfunction, the display shows the alarm codes. Refer to the chapter 'Troubleshooting' . Incorrect option selection The display shows the message some seconds and the Start/Pause indicator button flashes if : – You set a option that is not suitable for the programme. – You change the programme while it operates.
Maximum load Maximum spin speed Programme Temperature range 20 Programme description (Type of load and soil level) 4 kg Drying programme for cotton items. 2 kg Drying programme for synthetic items. 7 kg 1200 rpm To rinse and spin the laundry. All fabrics, except woollens and very delicate fabrics. Reduce the spin speed accordingly to the type of laundry. 7 kg To drain the water after programme with the optionRinse Hold set.
PROGRAMMES FOR TIMED DRYING Dryness Level Type of fabric Extra Dry For towelling materials Cottons and Linen (bathrobes, bath towels, etc) Cupboard For items to be stored Cottons and Linen (bathrobes, bath towels, etc) Cupboard Dry For items to be stored Synthetics and mixed fabrics (jumpers, blouses, underwear, household linen) Iron Dry Suitable for ironing Cottons and Linen (sheets, tablecloths, shirts, etc) Dry1) Load (kg) Spin speed (rpm) Suggested duration (mins) 4 1200 215 - 220 3 1
Programmes Load (kg) Energy conApproximate proWater consumption gramme duration (misumption (litre) (kWh) nutes) Cottons Eco Cotton Energy Saving Programme 60°C1) 7 1.05 55 185 Cottons 40°C 7 0.85 67 140 Synthetics 40°C 3 0.55 42 90 Delicates 40°C 3 0.55 63 65 Wool/Handwash 30°C 2 0.25 55 60 1) «Cotton Energy Saving programme » at 60°C with a load of 7kg is the reference programme for the data entered in the energy label, in compliance with EEC 92/75 standards.
On cotton programmes the maximum spin speed is reduced automatically. DELAY START With this option you can delay the start of a programme from 30 minutes to 20 hours. The display shows the related indicator. DOOR LOCKED INDICATOR DOOR The indicator Door shows when the door can be opened: • The indicator is on: the door cannot be opened. • The indicator flashes: the door is opening in some minutes. • The indicator is off: the door can be opened.
USING DETERGENT AND ADDITIVES 1. Measure out the detergent and the fabric conditioner. 2. Put the detergent and the fabric conditioner into the compartments. 3. Carefully close the detergent drawer. DETERGENT COMPARTMENTS Detergent compartment for prewash phase. Detergent compartment for washing phase. Compartment for liquid additives (fabric conditioner, starch). SETTING A PROGRAMME 1.
STAND BY Some minutes after the end of the washing programme, if you do not deactivate the appliance, the energy saving status activates. The energy saving status decreases the energy consumption when the appliance is on the standby: • All indicators and the display go off. • The indicator of button Start flashes slowly. Press one of the buttons to deactivate the energy saving status.
DAILY USE - DRYING ONLY • WARNING! Refer to Safety chapters. • If you set only 10 minutes of drying, the appliance performs only a cooling phase. This appliance is an automatic washer dryer. DRYING SETTING The recommended load size is 4 kg for cottons and linen, and 2 kg for synthetic items. 1. Load the laundry one item at a time. 2. Turn the programme dial to the programme applicable for the items to dry (cottons or synthetics).
To have a good drying performance do not exceed the maximum drying loads recommended in the user manual. Do not set a spin speed lower than the automatic speed of the set programme. WASHING & TIMED DRYING To have a good drying the appliance does not let you set a too low spin speed for the items to be washed and dried. 1. Press the button Drying Time to set the drying time value.
• • • • • – powder detergents for delicate fabrics (40 °C max) and woollens, – liquid detergents, preferably for low temperature wash programmes (60 °C max) for all types of fabric, or special for woollens only. Do not mix different types of detergents. To help the environment, do not use more than the correct quantity of detergent. Obey the instructions that you find on the on packaging of these products.
CARE AND CLEANING • WARNING! Refer to Safety chapters. • EXTERNAL CLEANING Clean the appliance with soap and warm water only. Fully dry all the surfaces. CAUTION! Do not use alcohol, solvents or chemical products. DESCALING If the water hardness in your area is high or moderate, we recommend that you use a water descaling product for washing machines. Regularly examine the drum to prevent limescale and rust particles. To remove rust particles use only special products for washing machines.
A B • • • • • • 1 • 2 • • • Place a container close to the pump (A) to collect any spillage. Pull out the emergency emptying hose (B), place it in the container and remove its cap. When no more water comes out, unscrew the filter. Turn the filter anticlockwise. Remove the filter. Use pliers, if necessary. When removing the filter, always keep a rag nearby to dry up any water spillage. Clean the filter under a tap, to remove any traces of fluff.
FROST PRECAUTIONS If the appliance is installed in an area where the temperature can be less than 0° C, remove the remaining water from the inlet hose and the drain pump. 1. Disconnect the mains plug from the mains socket. 2. Close the water tap. 3. Place the end of the emergency emptying hose and that of the inlet hose in a bowl placed on the floor and let water flow out of the hoses. 4. Set the Drain programme and let it operate until the end of the cycle. 5.
POSSIBLE FAILURES Problem The programme does not start. Possible solution • • • • • • The appliance does not fill with water properly. • • • • • • The appliance does not drain the water. • • • • • • Make sure that the mains plug is connected to the mains socket. Make sure that the appliance door is closed. Make sure that there is not a damaged fuse in the fuse box. Make sure that the Start/Pause has been pressed. If the delay start is set, cancel the setting or wait for the end of countdown.
Problem The washing results are not satisfactory. Possible solution • • • • Increase the detergent quantity or use a different detergent. Use special products to remove the stubborn stains before you wash the laundry. Make sure that you set the correct temperature. Decrease the laundry load. You cannot set an option. • Make sure that you press only the wanted button(s). The machine does not dry or does not dry properly: • Make sure that you have set a suitable drying programme for your laundry.
• 2 • Remove the power supply cable and the draining hose from the hose holders on the rear of the appliance. • Unscrew the three bolts. • Slide out the relevant plastic spacers. • • 1 Level the appliance by raising or lowering the feet. The feet may be tight to adjust as they incorporate a self locking nut, but the appliance MUST be level and stable. If necessary, check the setting with a spirit level. Any necessary adjustment can be made with a spanner.
• • Connect the hose to a tap with a 3/4”thread. Always use the hose supplied with the appliance. The inlet hose must not be lengthened. If it is too short and you do not wish to move the tap, you will have to purchase a new, longer hose specially designed for this type of use. WATER DRAINAGE The end of the drain hose can be positioned in three ways: BUILDING IN OVERVIEW This appliance has been designed to be built into the kitchen furniture.
counterclockwise with a 3mm wrench. Adjust the height and turn the nut clockwise to fix it. 600 mm min. 596 mm 560 mm ~10mm 555 mm min. 830 mm 818 mm 75 mm 60 mm 170 mm 100 mm We recommend that you keep the packaging and the transit bolts for any movement of the appliance. Installing anti-tiliting device If the height of the counter is 820 mm or lower, you cannot install the antitilting device.
16-22 mm X Ø 35 mm 416 mm A 22±1,5 mm 14 mm 595-598 mm Hinges To mount the hinges drill two holes (dia. 35 mm, depth 12.5-14 mm depending on the depth of door furniture) on the inner side of the door. To fix the hinges to the door use the screws for wood 1 and 2 supplied with the appliance (see below). B To align the door perfectly, loosen the screw, adjust the door and tighten the screw A again. The appliance is prearranged for a magnetic closure of the door.
D A C E B TECHNICAL DATA Dimension Width/ Height/ Depth/ Total depth 596 mm/ 818 mm/ 544 mm/ 560 mm Electrical connection Voltage Overall power Fuse Frequency 230-240 V 2050 W 13 A 50 Hz Level of protection against ingress of solid particles and moisture ensured by the protective cover, except where the low voltage equipment has no protection against moisture IPX4 Water supply 1) Cold water 2) Water supply pressure Minimum Maximum 0,5 bar (0,05 MPa) 8 bar (0,8 MPa) Maximum wash load Cotton
ENVIRONMENTAL CONCERNS with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office. Recycle materials with the symbol . Put the packaging in relevant containers to recycle it. Help protect the environment and human health by recycling waste of electrical and electronic appliances.
132905114-A-482017 WWW.ZANUSSI.
