User manual

Oven lamp
Warning! Be careful! There is the risk of electrical
shock!
Before you change the oven lamp:
• Switch off the oven.
• Remove the fuses in the fuse box or switch off the cir-
cuit breaker.
Put a cloth on the bottom of the oven for protection
of the oven light and glass cover.
1. Turn the glass cover anti-clockwise to remove it.
2. Clean the glass cover.
3. Replace the oven light bulb with applicable 300°C
heat-resistant oven light bulb.
Use the same oven lamp type.
4. Install the glass cover.
What to do if…
Warning! Refer to "Safety information" chapter.
Problem Possible cause Remedy
The oven does not heat up The oven is not switched on Switch on the oven
The oven does not heat up The clock is not set Set the clock
The oven does not heat up The necessary settings are not set Control the settings
The oven does not heat up The fuse in the fuse box is released Control the fuse. If the fuse is re-
leased more than one time, refer to a
qualified electrician.
The oven lamp does not operate The oven lamp is defective Replace the oven lamp
The pyrolysis function does not oper-
ate (the time display shows "AS")
Shelf support rails/oven shelf run-
ners are not removed
Remove shelf support rails / oven
shelf runners
The time display shows "Pyro" The oven needs pyrolytic cleaning Start the pyrolytic cleaning process
The time display shows an error code
which is not in the list
Electronic error Switch the appliance off and on again
through the fuse or the safety switch
in the fuse box. If the display shows
the error message again, refer to the
Service Force Centre
Steam and condensation settle on the
food and in the oven cavity
You left the dish in the oven for too
long
Do not leave the dishes in the oven
for longer than 15-20 minutes after
the cooking process ends
If you cannot find a solution to the problem yourself, con-
tact your dealer or the service centre.
The necessary data for the service centre is on the rating
plate. The rating plate is on the front frame of the oven
cavity.
We recommend that you write the data here:
Model (MOD.) .........................................
Product number (PNC) .........................................
15