Technical information

5. Extend the handle bar tube to full upright position and slide it into connecting with the

front fork.

6. Ensure that the handlebar is facing front, the brake on the left side and the throttle on

the right; before tightening the handlebar tube collar clamp using the enclosed wrench.

7. Plug in the two power connecting plugs into the sockets. The design of each plugs and

sockets are different. Connect the ones which best fit each other to finish the assembly.

NOTE: Handle bar height adjustment. Handle bar height can be easily adjusted by opening the

quick release on the handlebar tube to preferred height, then firmly closing quick release.

CHARGING THE BATTERIES

Before you ride the ZAPPY

for the first time you must charge the batteries for 4-6 hours using

only the supplied charger.

Option 1:

To charge the batteries, plug the charger into the charger socket located

on the rear side of the battery/ controller compartment. Then plug

the charger into a wall outlet.

Option 2: (for professional use only)