Technical information

Remove the screws from the battery compartment located at the front part of the footboard.

Disconnect the wires. Lift the battery box. Connect the battery and

charger using the charger convertible cable. Plug the charger into the wall

outlet.

RIDING THE ZAPPY

Once you have completed the initial charge you are ready to ride. Remember, this is not a toy.

The ZAPPY

can reach speeds up to 12.5 mph depending on the terrain and the weight of the

rider. You must wear a helmet and protective pads. You must also be aware of all local laws and

ordinances that govern and/or restrict the use of powered scooters. The laws and ordinances

vary greatly from municipality to municipality. It is your responsibility to know and abide by your

local restrictions.

To ride, plug the key into the key ignition and turn the key to the “ON”

position. The battery gauge will illuminate indicating that the battery is in

operation.

Hold onto the handlebars with both hands. Your left fingers will control the

brakes and your right thumb will control the thumb throttle. As you depress

the throttle lever with your thumb the speed will increase. Release the thumb throttle and apply

the brake to stop the scooter. You will control the speed of the scooter by using both the throttle

and the brake. When the brake handle is squeezed it cuts power to the throttle.

NOTE 1: You may use the balancing wheel (the smaller middle rear wheel) to balance the ZAPPY

when you want to ride with the front wheel raised. WARNING: Never try stunts beyond the

control of your skills. Never ride too fast for your skills or conditions.

Power switch button

off on

NOTE 2: When scooter is parked, press the power switch button to the “off” position; this will

avoid anyone from accidentally pushing the throttle causing the scooter to speed forward. Failure

to do this could lead to an accident.

FOLDING THE ZAPPY

1. Unplug the power connecting plugs.