Technical information

2. Unscrew the bolts and nuts from the connecting tube clamp using the enclosed allen
wrenches .
3. Lift the connecting tube (which is also attached to the handlebar tube).
4. Carefully place the handlebar tube on the footrest frame.
5. Finger screw the bolts and nuts back to the connecting tube clamp to avoid any
misplacements.
MAINTENANCE
Battery: (for professional use only)
The ZAPPY
3
is powered by three 12 volt, 7Ah, rechargeable batteries secured in a battery bag.
Other than recharging, these batteries need no maintenance. To prolong battery life, you must
recharge the battery after each use. You must also charge your ZAPPY
3
if it has not been used
for 30 days or more. If you must replace the batteries, they are located at the battery
compartment at the footboard. To get them, remove the compartment cover by loosening the
screws. To remove the batteries disconnect the wires from the battery terminals. Replace the
batteries with new ones and reconnect the wires. Follow the instructions on charging batteries to
charge the new batteries.
WIRING DIAGRAM (for professional reference)