SDS
Table Of Contents
- - SECTION 1: Identification
- - SECTION 2: Hazard(s) identification
- - SECTION 3: Composition/information on ingredients
- - SECTION 4: First-aid measures
- - SECTION 5: Fire-fighting measures
- - SECTION 6: Accidental release measures
- - SECTION 7: Handling and storage
- - SECTION 8: Exposure controls/personal protection
- - SECTION 9: Physical and chemical properties
- - SECTION 10: Stability and reactivity
- - SECTION 11: Toxicological information
- - SECTION 12: Ecological information
- - SECTION 13: Disposal considerations
- - SECTION 14: Transport information
- 14.1 UN number
- 14.2 UN proper shipping name
- 14.3 Transport hazard class(es)
- 14.4 Packing group
- 14.5 Environmental hazards
- 14.6 Special precautions for user
- 14.7 Transport in bulk according to Annex II of MARPOL and the IBC Code
- Information for each of the UN Model Regulations
- - SECTION 15: Regulatory information
- 15.1 Safety, health and environmental regulations specific for the product in question
- National regulations (United States)
- Superfund Amendment and Reauthorization Act (SARA TITLE III )
- Comprehensive Environmental Response, Compensation, and Liability Act (CERCLA)
- Right to Know Hazardous Substance List
- California Environmental Protection Agency (Cal/EPA): Proposition 65 - Safe Drinking Water and Toxic Enforcement Act of 1987
- Industry or sector specific available guidance(s)
- National regulations (United States)
- 15.2 Chemical Safety Assessment
- 15.1 Safety, health and environmental regulations specific for the product in question
- - SECTION 16: Other information, including date of preparation or last revision
Notation
df as dust and fumes
dust as dust
Fe calculated as Fe (iron)
fib/cm³ fibers/cm³
fib/ml fibers/ml
fume as fume
HyCarb calculated as hydrocarbons
i inhalable fraction
iv inhalable fraction and vapor
less1silica with less than 1 % free crystalline silica
natural natural
no_asb containing no asbestos fibers
noAsb_less1
Sil
contains no asbestos and less than 1% free crystalline silica
partml particles/ml
r respirable fraction
STEL short-term exposure limit: a limit value above which exposure should not occur and which is related to a 15-minute peri-
od (unless otherwise specified)
TWA time-weighted average (long-term exposure limit): measured or calculated in relation to a reference period of 8 hours
time-weighted average (unless otherwise specified
vap as vapors
8.2 Exposure controls
Appropriate engineering controls
General ventilation.
Individual protection measures (personal protective equipment)
Eye/face protection
Wear eye/face protection.
Skin protection
- Hand protection
Wear suitable gloves. Chemical protection gloves are suitable, which are tested according to EN 374. Check leak-
tightness/impermeability prior to use. In the case of wanting to use the gloves again, clean them before taking off
and air them well. For special purposes, it is recommended to check the resistance to chemicals of the protective
gloves mentioned above together with the supplier of these gloves.
- Other protection measures
Take recovery periods for skin regeneration. Preventive skin protection (barrier creams/ointments) is recommended.
Wash hands thoroughly after handling.
Respiratory protection
In case of inadequate ventilation wear respiratory protection.
Environmental exposure controls
Use appropriate container to avoid environmental contamination. Keep away from drains, surface and ground water.
SECTION 9: Physical and chemical properties
9.1 Information on basic physical and chemical properties
Appearance
Physical state liquid
Color various
Odor characteristic
Safety Data Sheet
acc. to 29 CFR 1910.1200 App D
ZAR® Interior Stain - Various Colors
Version number: REV 4.0
Replaces version of: 2021-05-12 (REV 3)
Revision: 2021-05-19
United States: en
Page: 8 / 19