User's Manual

General

Name the event file and make it on or off.

Trigger

You may activate the following trigger types as you wish depends on various conditions:

 Motion Detection: Click it on for using Motion Detection function as a sensor. You must configure

motion detection function before taking this as the trigger. Set minimum time interval between 2

triggers, and choose the desired detection area. The detection type individually stands for the

following meanings:

Start: The trigger would be activated when the target object starts to move.

Stop: The trigger would be activated when the target object stops to move.

Start-Stop: The trigger would be activated during the target object starts to move till it stops.

 Audio Detection: Click it on for using Audio Detection function as a sensor. You must configure

audio detection function before taking this as the trigger. Set minimum time interval between 2

triggers. The detection type stands for the following meanings individually:

Start: The trigger would be activated when the sound being made.

Stop: The trigger would be activated when the

sound being cut off.

Start-Stop: The trigger would be activated during the

sound being made and cut off.

 Periodical: This can be set the certain period(by minute) to start the trigger.

 On boot: The event is triggered when the IP Camera has been started over .

 Capacity Warning: This is triggered when SD Card capacity is be below the value you set.

 Network Link Down: The event is triggered when the network get disconnected.

 IP Notification: The event is triggered when the network being restarted or the IP being changed. And

there are optional network types to select, such as DHCP、Static IP and PPPoE.

Action

There are multiple choices for action taking which is optional for user to select all of them or part of them:

Send Image、Send Notification、PTZ Action or Night Mode.

 Send Image: You may set up where the image sent to, options like event server and SD card. You must

configure it first, please refer to Event Server.

 Send Notification: Firstly got to HTTP server configure the HTTP server URL, port, User ID,

Password, and Proxy server settings.

Note: The setting of URL should be the same as CGI.

 PTZ Action: Firstly configure the PTZ to set up the preset positions and tour you desired. You may

select to return to the last position after the event being triggered.