User's Manual

Trigger

You may activate the following trigger types as you wish depends on various conditions:

 Motion Detection: Click it on for using Motion Detection function as a sensor. You must configure

motion detection function before taking this as the trigger. Set minimum time interval between 2

triggers, and choose the desired detection area. The detection type individually stands for the

following meanings:

Start: The trigger would be activated when the target object starts to move.

Stop: The trigger would be activated when the target object stops to move.

Start-Stop: The trigger would be activated during the target object starts to move till it stops.

 Audio Detection: Click it on for using Audio Detection function as a sensor. You must configure

audio detection function before taking this as the trigger. Set minimum time interval between 2

triggers. The detection type stands for the following meanings individually:

Start: The trigger would be activated when the sound being made.

Stop: The trigger would be activated when the

sound being cut off.

Start-Stop: The trigger would be activated during the sound being made and cut off.

 Tampering Detection: This setting is set for the trigger will be started for the duration of tampering lasts

you configure. The duration range is from 5 seconds to 900 seconds

 Digital Input: This can be set to control the external alarm input of I/O port on the rear of the device to

start the trigger.

 Periodical: This can be set the certain period(by minute) to start the trigger.

 On boot: The event is triggered when the IP Camera has been started over .

 IR Cut Filter: This can be set the IR Cut filter mode to start the trigger.

 Capacity Warning: This is triggered when SD Card capacity is be below the value you set.

 Network Link Down: The event is triggered when the network get disconnected.

 IP Notification: The event is triggered when the network being restarted or the IP being changed. And

there are optional network types to select, such as DHCP、Static IP and PPPoE.

 PIR: Click it on for using as a sensor. You must configure tigger alternative before taking this as the

trigger. Set minimum time interval between 2 triggers.

Start: The trigger would be activated when the sound being made.

Stop: The trigger would be activated when the

sound being cut off.

Start-Stop: The trigger would be activated during the sound being made and cut off.