User manual

F531E & F731E User Manual
 Use the following IP address: Select this when the fixed IP address is set.
IP address: Enter the IP address of the device.
Subnet mask: Enter the subnet mask.
 Default gateway: Enter the default gateway.
 Use the following DNS server address: Select this when you set the fixed
address as the IP address of DNS server.
Primary DNS server: Enter the IP address of the primary DNS server.
Secondary DNS server: Enter the IP address of the secondary DNS
server, if necessary.
 HTTP port number: Select 80 in general situations. If you want to use a
port number other than 80, select the text box and enter a port number between
1024 and 65535.
 When you have set the HTTP port number to a number other than 80 on
the Network setting page or in the Setup Program, access the device by
typing the IP address of the device on the web browser as follows:
Example: when HTTP port number is set to 2000
http://192.168.1.100:2000/
Note:
The IP Camera needs to be rebooted after it finishes changing the network
setting completely.
Note:
If you connect the IP Camera with your computer directly, the default network
domain of camera is 192.168.1.xx
7.3.2. PPPoE(Point-to-Point Protocol over Ethernet)
If your ISP provides Dynamic IP with authentication by username and password,
type all PPPoE information in this part. When you use the PPPoE function, you
need to turn on the DDNS or IP Notification function at same time.
31