User's Manual

7.1.3 Initialize

 Reboot: Click this bottom to reboot this IP Camera. A confirmation dialogue will appear

and then click “OK” to process. It takes two minutes to reboot this IP Camera.

setting.

twork indicator

ents to the default setting. Don't turn off this IP Camera until the device

reboots.

e”

ve the setting data file to your specified

” and

Camera is adjusted according to the loaded data

grade the device software. Click “Browse” and select the file for

 Factory Default: Click this bottom to reset this IP Camera to the factory default

A confirmation dialogue will appear and then click “OK” to process. The ne

on this IP Camera will start to blink. This IP Camera will reboot automatically after

completing adjustm

 Backup Setting: You can save the setting data of this IP Camera into a file. Click “Sav

and follow the instructions on the browser to sa

location.

 Restore Setting: Download the saved setting data of this IP Camera. Click “Browse

select saved file. Click “OK” and this IP

and then restarted.

 Firmware Update: Up

upgrading. A confirmation dialogue will appear. Click “OK” to start upgrading. This IP

Camera will reboot upon completion.

Note:

Use only upgrade files that are special for this IP Camera. Otherwise problems may

occur. Don't turn off the IP Camera power or disconnect the network until the

upgrading is completed.