User's Manual

50
7.3.7 Wireless
The wireless network has to be set up by using cable network connection. After setting the
camera correctly, the wireless function can work with cable network connection. Wireless
settings must be the same as the access point or ad-hoc device. When changing the settings
they should always be made first in the camera and then in the wireless access point. This
ensures that the camera is always accessible when making changes.
is provided.
hoc device). If the sam
e name occurs
ciate with one particular access point.
pes supported by the camera.
Shows the wireless channel currently in use.
s. This can only be shown for the access point
 S
tatus of Wireless Network
This list is the result of network scan. The network is currently linked to will be shown in
blue. The following information
ESSID - The name of a wireless network (or ad-
several times this means that several access points for that network were found. The
camera cannot be configured to only asso
Mode - Shows if the network type is Master (access point or router) or Ad-Hoc
(another client).
Security - Shows which type of security the network uses. See below for the security
ty
Channel -
Signal strength - Shows the signal strength.
Bit rate - Shows the bit rate in Megabit/
currently in use. Note that the bit rate shown is the current rate, and that this value
may vary over time.