User's Manual

 Alarm

Motion Detection: Click it on for using  Motion Detection function as a sensor. You

can set motion detection function at the motion detection function page.

Note: You can set motion detection at motion detection page. (Please go “Setting →

Advance → Motion detection → Setting”) For more details, you can check Chapter 8.7.

Note： Motion Detection works only when the MPEG4 function is On.

Parameter: the parameter of CGI (defined in URL of HTTP → General) is

from your target device. For example, move=down.

 Message: message will show up in the form of Message = PTZ down. If your

target device didn’t support the parameter of message, you can’t see the

message. So you can just take the message as a note. For example: PTZ down.

