Owner`s manual

8.2. The top line shows all your Input Channels plus the slate mic and the

reference tone generator. The vertical line on the right shows your 10

available recording tracks. The bottom row of buttons control the

parameters of the matrix selections.

8.3. The above example shows DEVA set up to record 8 Digital inputs (for

example, from a Cameo or other Digital Board) to tracks 1 through 8 on the

Deva and an Analog mix from the mixer, routed through analog inputs 1

and 2 to tracks 9 and 10 on the Deva. The SLATE MIC and the TONE

generator are enabled for all 10 tracks.

8.4. To select either Analog or Digital inputs use the TOGGLE button. Selecting

a box once enables it, selecting it again disables it.

8.5. The PRE-FADER button allows you to choose whether each selection is Pre

or Post fader. For example, you can record the microphone on one channel

of the Deva post fader and on another pre-fader, so it is unaffected by the

mix. When an input is selected PRE-FADER it will appear as a WHITE ‘A’ or

‘D’ on the Matrix.

8.6. The PRESET button allows you to save and recall 5 preset matrices.

8.7. PHASE INVERT reverses phase of the selected input. A reversed phase

input will appear with a bar over the letter A or D.

8.8. CLEAR ALL empties the screen

8.9. This DISK CHANNEL MIX screen shows the Deva set up to record 2 Analog

inputs on Tracks 1 and 2, and 6 Digital inputs on tracks 3-8. The reference

tone goes to tracks 1 and 10, the Slate mic goes to track 10. A mix of 8

analog inputs also goes to Track

10.

9. Output Mix Menu

9.1. The OUTPUT MIX MENU routes the Inputs of the DEVA directly to the

outputs. This can be used to feed monitors, Video recorders, Comtek