Owner`s manual

M/S Stereo consists of a co-incident microphone pair

combining a forward facing microphone on one channel

and a bidirectional on another. To monitor them in stereo,

you combine the 2 microphones on the left side and

‘subtract’ the 2 microphones on the right. A simple M/S

matrix to monitor M/S stereo off the record channels would

look like this (where Ch 1 is the mid ‘M’ mic and Ch 2 is the

‘S’ side / bi-directional mic): (The indication for PHASE

INVERT is a bar over the inverted selection. In the

following image, the inverted selection is Disk Track 2, in

the Right headphone).

12.5.4.2. GET FACTORY PRESETS Opens a menu with 20

pre-programmed presets. NOTE – These pre-sets are all

set for monitoring DISK channels.

12.6. NORMAL HEADPHONE MENU

12.6.1. This menu only routes the Recorded Tracks to the headphones.

The monitoring is E to E. You are listening to what is being sent to

the hard drive. Check-Sum Error Correction insures that what is

being sent to the internal hard drive is being recorded there.