Owner`s manual

Deva IV and Deva V Owner’s Manual
Chapter 5
43
To S e t + 4 8 v Phantom Power, select the 48 Volts Caution! button, then select the buttons for the desired
channels. The 48 Volts button flashes red when activated.When phantom power is enabled for a channel,
the 48V On indicator appears red.
Note: If you chang
e a channel from Microphone input (Mic) to Line input (Line), 48V On is automatically disabled for that
channel.
High Pass Filter
Each analog input can have a high pass filter applied to it. You can enable the high pass filter for both line
and mic inputs.
Enabling the High Pass Filter
1. Press the High Pass Filter button
The button’s LCD indicator flashes green when pressed.
2. Set the High Pass Frequency.
Setting and changing the High Pass Frequency is outlined in the section Setting High Pass Frequency on
page 43.
3. Press the individual channel the High
Pass Filter shou
ld be applied to.
The HPF indicator changes to purple with the
high pass frequency indicated.
4. Repeat Step 3 for all channels, to en
able the high pass filter.
Note: You can set different frequencies for each channel, simply repeat steps 2 and 3 for each frequency.
Set
ting High Pass Frequency
Figure 5-1 Changing High Pass Frequency
To set the High Pass Frequency, do the following;
1. Press the High Pass Frequency button
You are prompted to enter the high pass frequency in Hz.
2. Use the keypad numbers to the frequency.
The default frequency is 70 Hz, the valid range is 30 Hz to 240 Hz.
3. Press High Pass Frequency button
This sets the frequency.
Note: The fr
equenc
y remains until the DEVA is powered down or you change it again.