User's Manual
Table Of Contents
- TRXLA3 Transmitter
- Home Screen
- Main Menu
- Sub Menus
- TIME CODE MENU
- TRANSMIT MENU
- RECORD MENU
- ZAXNET MENU
- AUDIO MENU
- SETUP MENU
- Firmware
- Inputting Audio
- Recommended Microphones
- Wiring Diagrams
- Operating Frequencies
- Product Support
- Specifications
- Zaxcom Warranty Policy and Limitations
Zaxcom TRXLA3
ZaxNet Menu
17
ZaxNet Receive Before Transmit Time
This menu adjusts the state of the ZaxNet transceiver. This also sets how long after boot-up up the TRXLA3
will search for ZaxNet time code before it begins transmitting its audio over ZaxNet for monitoring
purposes. This is so the TRX3LA can lock to ZaxNet time code source before the unit will send confidence
audio over ZaxNet.
Receive only mode.
The ZaxNet transceiver will only receive ZaxNet and NOT go into
transmit mode. Therefore no ZaxNet TC and/or audio will be
transmitted. This setting shuts off the ZaxNet transmitter.
Receive then Transmit mode.
After boot up the ZaxNet transceiver will search for a
ZaxNet signal for the selected time so it can receive and
lock time code before it begins to transmit TC and
confidence audio.
Transmit only mode.
The ZaxNet transceiver will only transmit ZaxNet TC and
audio and will NOT receive wireless TC or ZaxNet
commands. This setting shuts off the ZaxNet receiver.
RX TO TX TIME:
OFF (NORMAL RX)
ZAXNET RX TO TX:
0 SEC: TX ONLY
ZAXNET RX TO TX:
20 SEC