User`s manual

Chapter 3_____________________________________________ Zaxcom Control Surfaces User’s Manual
12
Figure 4-4 Input (#) – EQ page (Analog/Digital)
Pressing any other channel’s EQ key displays the new channel’s EQ page and illuminates only that channel’s CH
key.
NOTE: If you press and hold the EQ key, when you release the key you will exit the EQ page.
EQ key Shortcuts
While in the EQ page, the following keys are in effect:
ENTER key – alternately enables (inline) and disables (bypassed) ALL EQ settings for the current
channel. When a channel’s EQ has been bypassed, the settings are still maintained
until they are specifically modified.
RIGHT ARROW key – advances to the next filter band (note the green light in the buttons on the bottom
of the page).
LEFT ARROW key – advances to the previous filter band.
CH key – advances to the next EQ band.
UP ARROW key – changes the current filter’s, filter type:
o Band 1 – 3 are band filters selectable as Lo Shelf, Hi Shelf, Peaking or Off.
o Notch 1 & 2 are notch filters selectable as Off or On.
U key – resets the Level field of all bands of the current channel to 0.0, effectively negating
them.
L key – changes focus to the Level field.
F key – changes focus to the Frequency field.
Q key – changes focus to the Q field.
LOW EQ knob – changes the view to band 1 and adjusts the Level field.
MID EQ knob – changes the view to band 2 and adjusts the Level field.
HIGH EQ knob – changes the view to band 3 and adjusts the Level field.
JOG wheel – changes the value of Frequency or Q fields.
EQ key – advances to the EQ Memory page.
E key – advances to the EQ Memory page.
While in the EQ Memory page, the following keys are in effect:
CH key – toggles Load/Save mode.
1 thru 5 keys – pressing one of them loads/saves (depending on the mode) in the respective
memory.
EQ key – exits the EQ page
E key – exits the EQ page