User`s manual

Chapter 5_____________________________________________ Zaxcom Control Surfaces User’s Manual
16
Chapter 6 – Connector Pinouts
This section provides the pinouts for the connectors on the both Control Surfaces.
NOTE: All of the diagrams in this chapter show the solder side of each connector.
Power Connector
The Power Connector on the both Control Surfaces is a standard 4-pin XLR connector available at most
electronics stores. The both units require a power source of 9.5 to 18 VDC @ 1 A.
3 2
4 1
Figure 6-1 XLR-4F Power Connector Pin Numbering
Pin
Description
1
Ground
2
Ground
3
N/C
4
Input: 9.5 to 18 VDC (+)
Table 6-1 XLR-4F Pin Description
Control Cable, DB-9
The Control Surfaces use DB-9 connectors for both ends of the control cable to the Deva and Fusion recorders.
The pins are connected straight through between both ends.
Top row pins: 5, 4, 3, 2, 1
Bottom row pins: 9, 8, 7, 6
Figure 6-2 DB-9M Control Cable Connector Pin Numbering
Pin
DESC
Pin
DESC
1
Shield
6
Green
2
N/C
7
N/C
3
N/C
8
White
4
N/C
9
Black
5
Red
Table 6-2 DB-9M Pin Description