User`s manual

Zaxcom Control Surfaces User’s Manual _____________________________________________Chapter 3
9
Mix-12
Channel Strip
Each channel strip is composed of several items (from top to bottom):
TRIM rotary fader
Pre-fader input meter
BUS key
PFL key
EQ key
CH key
LINEAR fader
Channel strips are assigned in groups by the Fader Channel Assignment button in the Mix-12 Setup page:
Figure 4-1 Input (#) – Mix12 Setup page
Setting
Resulting Channel Strip Assignments
1-8 A, 1-4 D
Analog Inputs 1 – 8 are assigned to Ch Strips 1 – 8
Digital Inputs 1 – 4 are assigned to Ch Strips 9 – 12
1-6A, 1-6 D
Analog Inputs 1 – 6 are assigned to Ch Strips 1 – 6
Digital Inputs 1 – 6 are assigned to Ch Strips 7 – 12
1-4 A, 1-8 D
Analog Inputs 1 – 4 are assigned to Ch Strips 1 – 4
Digital Inputs 1 – 8 are assigned to Ch Strips 5 – 12
1-8 D, 1-4 A
Digital Inputs 1 – 8 are assigned to Ch Strips 1 – 8
Analog Inputs 1 – 4 are assigned to Ch Strips 9 – 12
Table 4-2 Mix-12 Fader - Channel Stripe Assignments
You can assign digital inputs 5 through 8 to the rotary faders on the Deva/Fusion.
IMPORTANT: You must ensure all channels controlled by the Mix-12 are NOT assigned to the rotary or
virtual faders on your recorder. Faders are assigned in the Faders page (MENU key  Faders button 
Fader Assign button).
Trim rotary fader
The TRIM rotary fader can attenuate up to 20 dB or boost up to 30 dB. The limits of attenuation and
amplification are controlled by the combination of the recorder and software. Rotating the fader counter-
clockwise reduces the pre-fader audio and rotating the fader clockwise increases the pre-fader audio.
The actual amount of amplification or attenuation can be seen on the Input (#) page on your recorder.
Pre-fader Input meter
This meter consists of a series of 18 LEDs. This meter is placed in the signal path after the TRIM rotary fader and