Specifications

MAIN MENU Recording Setup
17
Record Routing – Nomad Lite Only
The record routing in Nomad Lite is slightly different from the card routing in Nomad 10 or 12. Nomad Lite doesn’t
have a record enable matrix or a card routing matrix. With Nomad Lite, you can route all your inputs and all your record
busses to any one of the 10 record tracks.
NOTE: All ISO tracks are recorded Pre-Fade only. All Output busses are recorded Post-Fade
In the record routing page you select and highlight which card track you want to record on then you can choose what
source you what to assign and record on that channel. You can choose between all 10 analog inputs or any of your 6
output busses.
Record Enables – Nomad Lite Only
This menu controls which of the tracks are copied on Nomad Lite’s mirror compact flash card.
SHORTCUT: It is not necessary to remove record enable cross points from the Mirror Matrix. If a Primary
card track doesn’t have anything routed to it; it will NOT be recorded and therefore NOT written to the Mirror card.
This allows you to leave all of the Mirror tracks enabled. This makes it unnecessary to change the tracks being
mirrored every time you change a tracks record enable state.
The Record Routing menu is
only in Nomad Lite and takes
place of the Card Mix Matrix
Shows Card Tracks 3 and 4 will
Record Output buses 1 and 2
Shows Card Tracks 1 and 2 will
Record Inputs 1 and 2
“X” indicates which tracks will
be recorded on the Mirror CF
card