Specifications

MAIN MENU ZaxNet Settings
40
ZaxNet Setup Menu
Scroll for additional menu items
IFB Mode
• OFF – ZaxNet is off.
• RX – The ZaxNet transceiver is set to receive mode.
• TX – The transceiver is set to transmit mode. You will be able to transmit audio, timecode and wireless transmitter
commands. The unit will be the master for units with its Group ID.
• TX+RX – The IFB will stay in transmit mode unless you select to monitor audio via ZaxNet, at which point you will go
into receive mode. So if you set up one of your HP selects to monitor a wireless via ZaxNet when you select that
preset the IFB will go into RX mode to allow you to monitor for the duration until you deselect it
CAUTION: If you set the IFB Mode button to TX, be sure to attach an antenna. If you don’t, RF can leak into the
mic preamps.
Input Configure
To use ZaxNet you will need to set the INPUT CONFIGURE to 8 or higher. Click on: Input Configure page
TX Channel
Changes which frequency (2.403 – 2.475 GHz) Nomad will use to transmit IFB audio and ZaxNet commands on.
RX Channel
Sets the ZaxNet IFB receive channels frequencies you can chose up to six frequencies.
RX Audio Gain
Adjusts the receive audio level of the signal being received from a QRX IFB.
TX Audio Gain
Adjusts the transmit audio level of Nomads IFB that will be received by ERX receivers.
For monitoring - the channel numbers will
correspond with the 6 headphone selects in
the HP setup matrix.
So for example “RX FREQ 2” will be the 2nd
box in the “ZNET” select in the matrix