Specifications

NOMAD OPERATIONS Bus Routing Key

Card Routing – Nomad 10 and 12 Only

This controls which inputs are routed to which output buses on Nomad 10 and 12.

(For Nomad Lite, see

Record Routing page – Nomad Lite )

To toggle to the next matrix, press the BUS key.

The top line of the three pages indicates the following sources:

• Analog Inputs 1-6

• Aux Inputs

• o1, o2, o3, o4 – Output Buses 1-4

• R1, R2, R3, R4 – TA5 Inputs (Camera Returns / Line input 7-10)

• Digital Inputs 1-8 – the RED in the top line mean that those digital inputs can’t be assigned because they are

not available. To make the inputs available click

Input Configure page

Bus routing is fully cross-faded so the selection may be changed while in Record mode.

Setting a Crosspoint

Rotate the MENU knob to scroll through the matrix. Stop at the intersection of the input channel and output

channel, where you want to send that specific input. Press the MENU knob to cycle through the available cross

points, which are:

• X – post-fader

• P – pre-fader

• X – post-fader, phase inverted

• P – pre-fader, phase inverted

NOTE: To add the optional phase invert items to the list, while in the matrix press the STAR key. Then by

pressing the MENU knob, you will be able to cycle through the selections with phase invert.

Power cycling the unit will reset it to NO INVERSION mode but keep your phase invert choice.