Specifications

NOMAD OPERATIONS Setup Key
61
Pressing the Setup key
Analog Input Setup
Pressing the Setup key will take you to the analog Setup page where you can adjust the parameters of the 10 analog
inputs.
While in this page, pressing any of the multi-function keys will jump to the Setup page of the corresponding input
channels one through ten.
Adjustable Parameters
• Input Trim
• Input Type – Mic Level or Line Level
• Input Compressor
– Turns on the input compressor and sets link group
• 48 Volt Phantom Power – On or Off
• Input Delay – Variable from .0MS to 100MS in .0MS increments
• Mix 8 Trim – Choose between Normal and ZaxNet
• Normal – The trim knobs on the mix 8 adjust the input trim of the nomad or the digital trim if the mix8 mode is
set to digital.
• ZaxNet – The trim knobs control the TRX gain remotely (TRX with the unit code set to 001 is knob 1; TRX with
unit code 002 is knob 2 etc). The unit code is entered in the Zaxcom wireless transmitter via the Extended Menu.
• High Pass Filter – Turning on the HPF turns on a fixed frequency hardware cut. Adjusting the frequency adjusts a
software filter that is adjustable between 40Hz to 230Hz
• Two Variable Notch Filters
• Phase Invert
Input Compressor Linking
When using a stereo or surround microphone the input compressors (limiters) should be LINKED to insure that the
spatial integrity of the signal is maintained.
Your choices are: OFF, ON, GroupA, GroupB and GroupC. This allows you to have up to three different groupings.
For example, a stereo microphone on inputs 1 and 2 would have their limiters set to Group A. If the signal on input 1
needs limiting, the limiters on both 1 and 2 will activate together rather than just the limiter on channel 1.
Shows the Input level of
the Channel you are
adjusting
Two adjustable
Notch filters
Adjustable High
Pass filter
Input Compressor with
available Stereo Linking
(See below – for linking)