User manual

MAIN MENU ENG Advanced Setup Menu

USB Status

This page will display if the USB drive is ready for mirroring.

Allow Logging

Allow logging will turn on the logging feature which will allow Nomad to log warning and error messages

which then can be used by the factory to diagnose your Nomad. The logged messages are displayed on

the log screen. If logging is not turned on then Nomad will not log the errors.

Log Screen

This is where Nomad displays the logged errors and warnings.

Upgrade Code

This page is used to enter in a factory generated code to upgrade Nomad.

To enter the upgrade code you must directly enter in the code by using the alpha / numeric multi-function

keys. Warning by randomly entering in code numbers can cause your Nomad to lock up.

Trim Calibration Channels / Trim Calibrate

Trim calibration is used to calibrate the analog input trims. Calibrating the input trims will make the 6 XLR trims

accurate within +/- 1dB of each other. This is useful in setting up stereo microphones. Once the trims are

calibrated there should not be a need to ever re-calibrate.

Please note that Nomad’s with a serial number higher than 10688 have already been calibrated at the factory.

So it is unlikely that it will ever need to be re-calibrated.

See the end of the chapter for step by step calibration directions.

Slate Always On

• Normal - This is the typical setting that would be used. With this setting pressing and holding the slate key

will activate the slate mic.

• Forced - When you activate the slate mic this setting locks the slate mic in the on position. Note a power

cycle will deactivate the mic.

Headphone Phase

Headphone phase allows you to reverse the phase of the main headphone output.