User manual

NOMAD OPERATIONS Setup Key

Pressing the Setup key

Analog Setup Menu

Pressing the setup Key will take you to the analog setup menu where you can adjust the parameters of the 10

analog inputs. After pressing the setup key pressing one of the multi-function keys will jump to the setup menu

of the corresponding input - channel 1 through 10.

Scroll for additional menu items

Adjustable Parameters

• Input Trim – Adjusts the input trim.

• Input Type – Selectable between mic level and line level.

• Input Compressor – Turns on the input compressor and set compressor groups.

• 48 Volt Phantom Power – Turns on or off phantom power.

• Input Delay – Adjust the input audio delay and is variable from .0MS to 100MS in .1MS increments.

• Mix 8 Trim – Choose between Normal and ZaxNet

• Normal – The trim knobs on the mix 8 adjust the input trim.

• ZaxNet – The trim knobs control the TRX gain remotely (TRX with the unit code set to 001 is knob 1; TRX

with unit code 002 is knob 2 etc.).

• High Pass Filter – Turning on the HPF turns on a fixed frequency hardware filter. Adjusting the frequency

adjusts a software filter that is adjustable between 40Hz to 230Hz.

• Two Variable Notch Filters – Notch filters with independent adjustable frequencies.

• Phase Invert

Input Compressor Linking

When using a stereo or surround microphone the input compressors (limiters) should be linked to insure that

the spatial integrity of the signal is maintained. Nomad allows you to create three separate compressor groups.

For example, a stereo microphone on inputs 1 and 2 may have their limiters set to Group A. So if the signal on

input 1 needs compressing, the compressor on both 1 and 2 will activate together rather than just channel 1.