User manual

NOMAD OPERATIONS Tone Setup

Setting Up and Engaging Tone

Assigning Tone to Output Busses

To assign tone to an output bus, press the BUS Key and go to the analog assign matrix to select which output bus

will receive tone when tone is engaged. Please note that only the busses with tone routed to it will output the

slate tone when the visual time code slate tone is activated.

Assigning tone to card tracks

To assign tone to card tracks, press the BUS Key and go to the tone enable matrix to select which card tracks will

receive tone when tone is engaged.

Engaging tone

To toggle tone generation on/off, press and hold the SETUP Key for 1.5 seconds.

Adjusting the tone frequency and level

Tone level and frequency can be adjusted in the ENG setup menu. It is advised to keep the tone level at -20dB

for most operations.

Shows that output busses 1, 2 and 3 will

output tone when tone is engaged.

Shows that card tracks 1 and 2 will

record tone when tone is engaged.

Adjusts Tone Frequency

Adjusts Tone Level