Specifications

Zaxcom ZFR 200 / 300 Manual____ _______________ ___ ___Extended Menu
12
IFB Voting Enable – this menu will not appear if the IFB settings allow the ZFR to go into transmit mode.
This menu allows you to enable / disable the IFB Voting function.
The purpose of the voting is to allow the ZFR to choose and switch to the stronger signal from two
different ZaxNet transmitters. One purpose of this is if you are on a large set you can place a second
transmitter at a different location and the ZFR will choose the stronger signal. Just set the second
transmitting frequency a minimum of 2MHz higher than the first unit.
IFB Receive to Transmit time
IFB RX TO TX:
NORMAL RX
IFB RX TO TX:
20 SECS
This menu sets how long after power up that the ZFR will search for ZaxNet timecode before it begins
transmitting IFB audio for monitoring purposes.
The ZFR will receive ZaxNet only
and NOT transmit ZaxNet TC and audio.
Adjustable from 1 up to 20 Seconds.
After boot up the ZFR will search for a
ZaxNet signal for XX seconds before it
begins to transmit ZaxNet TC and Audio
IMPORTANT: After changing this setting a re-boot is required
IFB RX TO TX:
NORMAL RX
IFB RX TO TX:
20 SECS
NOTE: This Page only will appear if you have the IFB RX TO TX mode set to NORMAL RX and
RX MODE is not set to OFF. Meaning that if the TRX-742 IFB will ever be in a transmit
mode IFB voting no longer applies and will not be available.
IFB VOTING
NORMAL (OFF)
IFB RX TO TX:
0 SECS: TX ONLY
The TRX will transmit ZaxNet TC and
audio only and will NOT receive
wireless TC.