Specifications

Zaxcom ZFR 200 / 300 Manual____________ Inputting Audio/Wiring Diagrams
24
Inputting Audio
The ZFR200 / ZFR300 use an unbalanced microphone input via a 3-pin micro-LEMO connector.
You can use an unbalanced dynamic microphone or a powered lavaliere.
You can use a line-level input though an inline pad is required on the standard dynamic
microphone input cable (XLR-3 to 3-pin micro-LEMO).
When using a phantom powered microphone with the ZFR200 / ZFR300, you must use an external
48 VDC power supply since the ZFR doesn’t supply 48 volts.
Because the ZFR doesn’t transmit a UHF signal like Zaxcom wireless transmitters do – there are NO
lavaliere limitations in terms of RF resistances. Any microphone the uses less than 3.3 volts will
work with the ZFR.
Wiring Diagrams
The following 3-pin micro-LEMO connectors mate with the microphone connector:
• FGB.00.303.CLAD.22 – has a latch with a pull release. (recommended for RFI prevention)
• FVB.00.303.NLA – has a latch with a twist release.
Two Wire microphone configuration
Three Wire microphone configuration
Please contact your microphone manufaturer.
NOTE: It is recommend that the ground gets attached to the shell even though the ZFR doesn’t
transmit RF that will interfere with the microphone. This way you can use the same
microphone for one of our transmitters.