User manual

Zaxcom ZFR 200 / 300 Manual Main Menu
10
SD Card Format
This menu will only appear if a card was inserted prior to booting up
The Micro SD card is erased and formatted from this menu. Please note that even though many cards are sold
preformatted, you must format the card in the ZFR prior to any recording. Only cards formatted in the ZFR will
work properly.
Before formatting the card, you may want to name the ZFR. When you name the ZFR that name is included in
the recorded file names. By naming the ZFR it makes it easier to differentiate files from different recorders. So
for example you can name the card with the talents name or any other unique identifier. The card name menu
is located at the end of the extended menu.
To Format an SD Card:
1. With the power off, insert the memory card into the media slot with the card label to the back of the unit.
Press the card all the way in until it “clicks”.
2. Power up the transmitter and advance to this menu.
3. Press the INC key 5 times.
4. You will see “FORMATTING FAT 32” displayed on the screen.
5. After about a minute the ZFR will displays “SUCCESS” or “FORMAT FAILED ERROR”.
6. If “SUCCESS” appears power cycle the ZFR.
7. If you see “FORMAT FAILED ERROR” try to re-format the card and if it fails again it is not advised to use
that card in the recorder.
Time Left on Card
This page displays the remaining time left on the card and the time already recorded on the card.
This page will not be displayed if no card is present.
TIME LEFT 20H
TIME USED 4H
PRESS UP KEY 5X
TO ERASE CARD