User manual

Zaxcom ZFR 200 / 300 Extended Menu

IFB Mode

This menu adjusts the mode of the ZaxNet IFB transceiver and how long after power up that the ZFR’s

ZaxNet receiver will search for ZaxNet time code before it begins transmitting IFB audio for monitoring

purposes. This is necessary if you want your transmitter to lock to ZaxNet time code before you use

your ZaxNet transmitter to send confidence audio.

Please note that after changing this setting a re-boot is required.

ZaxNet Receive Frequency Set

This is where the ZaxNet receive frequency is set.

This is the frequency that the ZFR’s ZaxNet receiver will receive wireless ZaxNet time code from - as long as

this frequency matches the frequency of the corresponding ZaxNet transmitter. The ZaxNet transmitter can

be a QRX with QIFB, Nomad, TRX900CL or IFB100/200. The ZFR can also receive ZaxNet time code from

another ZFR or TRX transmitter that is transmitting ZaxNet on this frequency.

Receive only mode.

The ZaxNet transceiver will only receive ZaxNet and NOT

into transmit mode. Therefore no ZaxNet TC and/or audio

will be transmitted. This shuts off the ZaxNet transmitter.

Receive then Transmit mode.

After boot up the ZaxNet transceiver will search for a

ZaxNet signal for the selected time so it can receive and

lock time code before it begins to transmit TC and

confidence audio.

IFB RX TO TX:

OFF (NORMAL RX)

IFB RX TO TX:

20 SECS

IFB RX TO TX:

0 SECS: TX ONLY

Transmit only mode.

The ZaxNet transceiver will only transmit ZaxNet TC and

audio and will NOT receive wireless TC or ZaxNet

commands.

When the ZaxNet receiver is receiving a ZaxNet signal you will see:

ZaxNet receive frequency and RX shows that ZaxNet is being received

ZaxNet signal strength meter

Signal strength

RXFREQ: 2.403

SIGNAL: 28

RXFREQ: 2.403