User manual

Zaxcom ZFR 200 / 300 Manual Firmware

Firmware

Each unit is shipped with the latest firmware version installed. As newer firmware becomes available, it can

be downloaded from the Zaxcom website:

http://www.zaxcom.com/software-updates

Newer version of Beta software may be found on the Zaxcom Forums:

http://www.zaxcom.com/forum

Each time a unit is powered up, the firmware version number is displayed briefly on the LCD screen. Pressing

the DEC key during the boot up will slow down the screen to allow easier viewing of the information.

Updating ZFR Firmware

1. Format a card in the ZFR

2. Download the firmware from the Zaxcom website and load it onto the formatted card.

3. Make sure the ZFR is powered down and Insert the card into the ZFR.

4. Simultaneously hold down the INC and DEC keys while powering up the unit.

5. The screen will display “BURN ROM” with the version of firmware you are loading.

6. From power up to “DONE” will take about 30 seconds.

7. Upon completion, cycle the power to run on the new version.

WARNING: Do not power down the unit during the update process, and before updating the software be sure

to insert a fresh set of batteries. If the unit should lose power during the upgrade, it will need to be sent back to

Zaxcom for repair.