zBoost Mobile1TM ZB245 Cellular Signal Booster Need help? www.zBoost.com Tech Support 800-871-1612 Mon.- Fri.
IT IS VERY IMPORTANT TO POWER YOUR SIGNAL BOOSTER USING A SURGE PROTECTED AC POWER STRIP WITH AT LEAST A 1000 JOULE RATING. ! FAILURE TO DO THIS WILL VOID YOUR WARRANTY IN THE EVENT OF A POWER SURGE OR LIGHTNING STRIKE. THE SIGNAL BOOSTER UNIT IS DESIGNED FOR USE IN AN INDOOR, TEMPERATURECONTROLLED ENVIRONMENT (LESS THAN 150 DEGREES FAHRENHEIT). IT IS NOT INTENDED FOR USE IN ATTICS OR SIMILAR LOCATIONS SUBJECT TO TEMPERATURES IN EXCESS OF 150°F. ! Contents Package Contents . . . . . . . . . . . . . . .
Installation Options Vehicle Installation Option 1. Attach the Mounting Bracket to the vehicle’s dashboard. • Clean the area where the bracket is to be mounted with the alcohol wipe included. Allow the area to dry. 4. Attach the zBoost Mobile1 to the Mounting Bracket.
6. Power up your zBoost Mobile1. Connect the power cable to the mini-USB port on the bottom of the zBoost Mobile1. Then insert the adapter into the vehicle 12V DC power source. Use only the supplied zBoost power supply. While the zBoost Mobile1 may remain on, leaving the zBoost Mobile1 on in a vehicle when it is not running may discharge the battery in a day or two. Also note that some 12V DC power sources are shut down when the vehicle ignition is turned to off.
Adjusting the zBoost Mobile1 Arms Various sized arms are included with your zBoost Mobile1. These provide you with options to customize the zBoost Mobile1 to fit virtually any cell phone. • To change arms, gently lift the arm upward until the arm slides free from the zBoost Mobile1. • To reposition arms, move the arm above a different slot on the zBoost Mobile1 and gently slide the arm down until the arm is firmly in place.
Additional FAQ: What hours can I contact tech support? Technical Support can be reached from 8.30am to 5:30pm EST by calling (800-871-1621), or by email, at support@zBoost.com How does weather affect the performance of my Outside Antenna? Water vapor (e.g. rain, fog, snow or other precipitation) creates an effective filter to cellular signal. In times of heavy precipitation, you may see less performance.
Safety and Recommendations WARNING: Connecting the Signal Booster directly to the cell phone with use of an adapter will damage the cell phone. WARNING: Use only the power supply provided in this package. Use of a non-zBoost product may damage your equipment.
Limited 1 Year Warranty Warranty Registration at www.zBoost.com zBoost warrants every zBoost product to be free from defects in material and workmanship under normal use for the warranty period of one year. Who Is Covered? You must have proof of purchase to receive warranty service. A sales receipt or other documentation showing the product purchased and the purchase date is considered proof of purchase.
Signal Booster Specifications zBoost Mobile1 Model Number ZB245 Connectors SMA-Female Antenna Impedance 50 Ohms Frequency 824-894 MHz/1850-1990 MHz 800 MHz 3 1900 MHz Power output for single cell phone (dBm) Uplink Downlink Noise Figure (typical downlink/uplink) 22.9 -28.0 25.2 -29.1 3 dB nominal Isolation > 40 dB Power Requirements 5.5 V 1A Each Signal Booster is individually tested and factory set to ensure FCC compliance.
