User's Manual

Wireless Extenders

YX500-CEL Installation Guide

Wall Mounting the Base Unit

The Base Unit can also be easily mounted on a wall using the included mounting

bracket hardware. The Base Unit should be a minimum distance of 12" from the

ceiling so their is clearance for the Base Unit antenna extension.

Perform the following steps to mount the Base Unit on a wall:

1) Remove the mounting bracket from the Base Unit

2) Attach the coaxial cable, which should already be attached to the Signal

Antenna, to the Base Unit.

3) Attach the antenna to the Base Unit.

4) Attach the power supply to the Base Unit and plug the power supply into an

outlet. See the Troubleshooting section if a Red light lights up.

5) Holding the Base Unit, adjust its position on the wall until the LEDs shine a

steady green. The Base Unit can be mounted on the wall with the antenna

pointing to the ceiling or towards the floor.

6) Fasten the mounting bracket to the wall using the self-tapping wall/ceiling

anchors

7) Snap the Base Unit into the mounting bracket.

Note:

If you are unable to position the Base Unit so that the Power light

shines a steady green, you may have to move the Base Unit to

another wall in the room.

Confirm that the

YX500-CEL is

Working Properly

Perform the following steps to confirm that the YX500-CEL is now working

properly:

1) Unplug the YX500-CEL Base Unit power cord.

2) Turn on your Cellular cell phone and check the signal meter.

3) Turn off your Cellular cell phone.

4) Plug-in the YX500-CEL Base Unit power cord.

5) Hold your Cellular cell phone about 2 to 3 feet from the Base Unit and

then turn it on. Wait up to 1 minute for the cell phone to register the

signal coming from the Base Unit.

6) If the signal meter shows an improvement, the YX500-CEL is working

properly. You now have Wireless Where You Want It™.