Product Specs

15
Kepler FX6 Facial Recognition Device — Product Specifications
6 Appendix
Table 3- 1 Common models
Model
Product
Code
Package and Accessory
Packing
FX6-B
FX6-B
Device, 12 V power supply, packing cotton,
user manual, and installation backplane
1 piece/box
FX6-Z
FX6-Z
Device, 12 V power supply, packing cotton,
user manual, and common column support
1 piece/box
FX6-L
FX6-L
Device, 12 V power supply, packing cotton,
user manual, and 1.4-m column support
1 piece/box
FX6-S-B
FX6-S-B
Device (with the ID card reader), 12 V
power supply, packing cotton, user manual,
and installation backplane
1 piece/box
FX6-S-Z
FX6-S-Z
Device (with the ID card reader), 12 V
power supply, packing cotton, user manual,
and common column support
1 piece/box
FX6-S-L
FX6-S-L
Device (with the ID card reader), 12 V
power supply, packing cotton, user manual,
and 1.4-m column support
1 piece/box
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may cause
undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party
responsibleforcompliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one of more of the following measures:
1) Reorient or relocate the receiving antenna.
2) Increase the separation between the equipment and the receiver.
3) Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected. Consult the dealer or an experienced radio/TV
technician for help.
The device has been evaluated to meet general RF exposure requirement.This
device should be installed and operated with a minimum distance of 20cm between the device and
your body.