AS240 2x2 Dual Band 802.
Package Contents One Indoor access point Screws for hard ceiling Screws for suspended ceiling Mounting Bracket Installation Requirements TERMS OF USE: All Ethernet cabling runs suggest using CAT.6, 24 AWG (or above) Shielded Twisted Pair (STP) cabling. In addition, please cut the cable into a proper length, strip the cables on both ends, and crimp the wires into RJ45 connectors.
Position the mounting bracket holes (with indents up) over the pilot holes. Insert a fastener into each mounting hole and use a washer together with wing nut to tighten. If necessary, drill or cut a cable access hole in the ceiling tile large enough for the Ethernet cables. Pull the cable through the access hole until you have about 1 foot of cable protruding from the hole. Connect the Ethernet cable to the access point.
Powering the Access Point Connect the PoE cable into the WAN/PoE IN port of the device. Note: Please wait for 5-10 seconds while powering on.
Access Point Configuration In a default access point configuration, the access point default AP mode is TAP mode, and obtains IP addresses from DHCP Option 43 protocol. Note: In TAP mode, the AP must be able to go with Wireless LAN Controllers (WLCs) for bulk configuration and performing other commands of access points. Please refer to WLC QSG for settings first, then go back to finish the AP configuration. https://www.zcom.com.tw/index/downloads?keyword=&meterial_type=49 Step 1. Power on the access point.
If the access point cannot connect to the WLC by DHCP broadcast, please refer to the following optional settings. Optional: Set up a static IP address Note: The following procedure assumes that Windows 10 is the operating system. Procedures for other operating systems are similar. Step 1. On your computer, configure your network adapter from the “Local Area Connection “settings as follows: ˙ Step 2.
Fat and Thin AP Mode Switching Click SystemAPMode, select the AP mode you want then click SAVE&APPLY.
Technical Specifications AS240 Dimensions (L x W x H) Ø 175 mm × 39.1 mm Weight 310g Networking Interface (1) WAN/PoE, 10/100/1000Mbps Ethernet Ports (1) LAN10/100/1000Mbps Ethernet Ports Buttons Reset Power Method PoE 802.3af / 802.3at Power Supply DC 48V, 630mA Max. Power Consumption 10W Wi-Fi Standards 802.11 a/b/g/n/ac/ax , MIMO 2x2:2 Wi-Fi Physical Rates Wireless Security 2.
Compliance FCC This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
CE Marking CE marking on this product represents the product is in compliance with all directives that are applicable to it. Note: This device meets Max. TX power limit per ETSI regulations. RoHS/WEEE Compliance European Directive 2012/19/EU requires that the equipment bearing this symbol on the product and/ or its packaging must not be disposed of with unsorted municipal waste. The symbol indicates that this product should be disposed of separately from regular household waste streams.
Optional Accessories PN Item Picture AS240 66-400008-00N Mounting Bracket yes 61-100049-00N Screws for hard ceiling yes 61-100050-00N Screws for suspended ceiling yes Note: When ordering power adaptors, you must specify the destination region by indicating -US, -EU instead of -XX. Contact Information All information may be changed by Z-COM at any time without prior notice or explanation to the user. For further information please refer to our website: www.zcom.com.
